UNISONIC TECHNOLOGIES CO., LTD U74HC04 CMOS IC HEX INVERTERS DESCRIPTION The U74HC04 devices contain six independent inverters. They perform the Boolean function Y A in positive logic. FEATURES * Wide Operating Voltage Range of 2V to 6V * Outputs Can Drive Up To 10 LSTTL Loads * Low Power Consumption, 2μA Max ICC * Typical tpd=8ns * ±4mA Output Drive at 5V * Low Input Current of 1uA Max ORDERING INFORMATION Ordering Number Lead Free U74HC04L-D14-T - Halogen Free U74HC04G-D14-T U74HC04G-S14-R U74HC04G-P14-R Package Packing DIP-14 SOP-14 TSSOP-14 Tube Tape Reel Tape Reel MARKING DIP-14 www.unisonic.com.tw Copyright © 2014 Unisonic Technologies Co., Ltd SOP-14 / TSSOP-14 1 of 6 QW-R502-919.B U74HC04 CMOS IC PIN CONFIGURATION FUNCTION TABLE (each gate) INPUT(A) L H OUTPUT(Y) H L LOGIC DIAGRAM (positive logic) Fig.1 logic diagram for U74HC04 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 6 QW-R502-919.B U74HC04 CMOS IC ABSOLUTE MAXIMUM RATING (TA = 25°С, unless otherwise specified) (Note 2) PARAMETER SYMBOL RATINGS UNIT Supply Voltage VCC -0.5~7 V Input Clamp Current(VI<0) IIK ±20 mA Output Clamp Current(VO<0) IOK ±20 mA Output Current IOUT ±25 mA VCC or GND Current ICC ±50 mA Storage Temperature TSTG -65 ~ +150 °C Note: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. The input and output voltage ratings may be exceeded if the input and output current ratings are observed. THERMAL DATA PARAMETER Junction to Ambient SYMBOL DIP-14 SOP-14 TSSOP-14 θJA UNIT °C/W RECOMMENDED OPERATING COMDITIONS (TA = 25°С, unless otherwise specified) PARAMETER Supply Voltage Input Voltage Output Voltage Operating Temperature SYMBOL VCC VI VO TA t/v Input transition rise/fall time RATINGS 80 86 113 CONDITIONS Operating MIN 2 0 0 -40 TYP 5 VCC =2V VCC =4.5V VCC =6V MAX 6 VCC VCC +85 1000 500 400 UNIT V V V °C MAX UNIT ns STATIC CHARACTERISTICS (TA = 25°С, unless otherwise specified) PARAMETER SYMBOL Positive-Going Input Threshold Voltage VIH Negative-Going Input Threshold Voltage VIL High-Level Output Voltage Low-Level Output Voltage Input Leakage Current VOH VOL II Quiescent Supply Current ICC Input Capacitance CI TEST CONDITIONS VCC =2V VCC =4.5V VCC =6V VCC =2V VCC =4.5V VCC =6V VCC =2V, IOH=-20μA VCC =4.5V, IOH=-20μA VCC =6V, IOH=-20μA VCC =4.5V, IOH=-4mA VCC =6V, IOH=-5.2mA VCC =2V, IOH=20μA VCC =4.5V, IOH=20μA VCC =6V, IOH=20μA VCC =4.5V, IOH=4mA VCC =6V, IOH=5.2mA VCC = 6V, VI=VCC or GND VCC = 6V, VI= VCC or GND IO=0 VCC =2V to 6V UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN 1.5 3.15 4.2 TYP V 0.5 1.35 1.8 1.9 4.4 5.9 3.98 5.48 1.998 4.499 5.999 4.3 5.8 0.002 0.001 0.001 0.17 0.15 ±0.1 3 V 0.1 0.1 0.1 0.26 0.26 ±100 V V V V V V V V V V nA 2 μA 10 pF 3 of 6 QW-R502-919.B U74HC04 CMOS IC DYNAMIC CHARACTERISTICS (Input: tR, tF=6ns, CL=50pF; PRR≤1MHz) See Fig. 2 and Fig. 3 for test circuit and waveforms. PARAMETER SYMBOL TEST CONDITIONS VCC=2V Propagation delay from input tPLH/tPHL VCC=4.5V (A) to output(Y) VCC=6V VCC=2V Rise/fall time for output(Y) tt VCC=4.5V VCC=6V MIN TYP 45 9 8 38 8 6 MAX 95 19 16 75 15 13 UNIT ns ns ns ns ns ns MIN TYP 20 MAX UNIT pF OPERATING CHARACTERISTICS PARAMETER Power Dissipation Capacitance SYMBOL CPD TEST CONDITIONS No Load UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 6 QW-R502-919.B U74HC04 CMOS IC TEST CIRCUIT AND WAVEFORMS TEST tPLH/tPHL S1 Open Inputs VIN VCC tr, tf 6 ns VM VLOAD CL VCC/2 VCC 50 pF 90% VCC 90% Input 10% 10% tr 0V tf VIN Input VM VM 0V t PHL t PLH 90% Output V OH 90% VM VM 10% t PHL 10% tr t PLH tf 90% 90% Output VM 10% tf UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw VOL V OH VM 10% tr VOL 5 of 6 QW-R502-919.B U74HC04 CMOS IC UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 6 of 6 QW-R502-919.B