150mA Low-Noise LDO Voltage Regulator CORPORATION CLM5205 FEATURES GENERAL DESCRIPTION • Ultra-Low Noise Output • High Output Voltage Accuracy 150mA Output • Guaranteed • Low Quiescent Current • Low Dropout Voltage Tight Load and Line Regulation • Extremely • Very Low Temperature Coefficient • Current and Thermal Limiting Protection • Reverse-Battery • "Zero" OFF-Mode Current • Logic-Controlled Electronic Enable The Calogic CLM5205 is a low noise, low dropout voltage regulator featuring ultra low ground current (800uA at 100mA output) and tighter than 1% initial accuracy with a logic compatible ON/OFF switching input. Designed for hand-held battery powered devices, the CLM505 is switched by a CMOS or TTL compatible logic signal. When disabled, power consumption drops nearly to zero. Prolonging battery life, the ground current of the CLM5205 increases only slightly in dropout. Major features of the CLM5205 include a reference bypass pin for excellent low-noise performance, protection against reversed battery, current limiting, and overtemperature shutdown. APPLICATIONS The CLM5202 is available in several fixed voltages and an adjustable output voltage version in a small SOT-23-5 package. The pinout is smaller to the LP2980 with significantly better performance. Telephones • Cellular • Laptop, Notebook, and Palmtop Computers • Battery Powered Equipment VCC and VPP Regulation/Switching • PCMCIA • Consumer/Personal Electronics • SMPS Post-Regulator/ DC toDC Modules • High Efficiency Linear Power Supplies ORDERING INFORMATION Part Voltage CLM5205M CLM5205M-5.0 CLM5205M-4.7 CLM5205M-4.0 CLM5205M-3.6 CLM5205M-3.3 CLM5205M-3.0 CLM5205M-2.85 PIN CONFIGURATION 3 EN 2 GND Adjustable 5.0V 4.7V 4.0V 3.6V 3.3V 3.0V 2.85V Package SOT-23-5 SOT-23-5 SOT-23-5 SOT-23-5 SOT-23-5 SOT-23-5 SOT-23-5 SOT-23-5 Temperature Range -40oC to +125oC -40oC to +125oC -40oC to +125oC -40oC to +125oC -40oC to +125oC -40oC to +125oC -40oC to +125oC -40oC to +125oC TYPICAL APPLICATION 1 V IN 3 EN 2 GND 1 V IN VOUT VIN + + 1µF GND EN VOUT REF BYP 5 4 CLM5205M-XX 1V-13 VOUT ADJ 4 5 CLM5205M (ADJUSTABLE) 1V-15 REF. BYP (OPT.) 0.01µF 1V-14 CALOGIC CORPORATION, 237 Whitney Place, Fremont, California 94539, Telephone: 510-656-2900, FAX: 510-651-3025 CLM5205 CORPORATION ABSOLUTE MAXIMUM RATINGS RECOMMENDED OPERATING CONDITIONS Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Electrical specifications do not apply when operating the device beyond its specified Operating Ratings. Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5V to 16V Operating Junction Temperature Range . . . . -40oC to +125oC ENABLE Input Voltage. . . . . . . . . . . . . . . . . . . . . . . . 0V to VIN SOT-23-5 θJA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Note 1 Power Dissipation . . . . . . . . . . . . . . . . . . . . . Internally Limited Lead Temperature (Soldering 5 seconds) . . . . . . . . . . . 260oC Operating Junction Temperature Range . . . . -40oC to +125oC Input Supply Voltage . . . . . . . . . . . . . . . . . . . . . . -20V to +20V ENABLE Input Voltage . . . . . . . . . . . . . . . . . . . . -20V to +20V DC ELECTRICAL CHARACTERISTICS Limits in standard typeface are for TJ = 25oC and limits in boldface apply over the junction temperature range of -40oC to +125oC. Unless otherwise specified, VIN = VOUT + 1V, IL = 100µA, CL = 3.3µF, and VENABLE ≥ 2.0V. SYMBOL PARAMETER VO Output Voltage Accuracy ∆VO ∆T Output Voltage Temperature Coeficient ∆VO VO MIN TYP -1 -2 MAX UNITS 1 2 % CONDITIONS Variation from specified VOUT 40 ppm/oC Line Regulation 0.004 % VIN = VOUT + 1V to 16V ∆VO VO Load Regulation 0.04 % IL = 0.1mA to 150mA (Note 3) VIN - VO Dropout Voltage (Note 4) 17 80 115 140 165 mV IL = 100µA IL = 20mA IL = 50mA IL = 100mA IL = 150mA IGND Quiescent Current <1 µA VENABLE ≤ 0.7V (Shutdown) IGND Ground Pin Current (Note 5) 80 160 350 720 1300 µA VENABLE ≥ 2.0V , IL = 100µA IL = 20mA IL = 50mA IL = 100mA IL = 150mA PSRR Ripple Rejection 75 dB ILIMIT Current Limit 320 mA VOUT = 0V ∆VO ∆PD Thermal Regulation 0.05 %/W (Note 6) eno Output Noise 260 nV/√ Hz 0.4 V 0.01 2 µA (Note 2) IL = 50mA, CL = 4.7µF, 0.01µF from Ref BYP to ground ENABLE INPUT VIL IL IIH Input Voltage Level Logic Low Logic High ENABLE Input Current 2.0 OFF ON VIL ≤ 0.18V VIH ≥ 2.0V CALOGIC CORPORATION, 237 Whitney Place, Fremont, California 94539, Telephone: 510-656-2900, FAX: 510-651-3025 CLM5205 CORPORATION Note 1: Absolute maximum ratings indicate limits beyond which damage to the components may occur. Electrical specifications do not apply when operating the device outside of its rated operating conditions. The maximum allowable power dissipation is a function of the maximum junction temperature, TJ(MAX), the junction-to-ambient thermal resistance, θJA, and the ambient temperature, TA. The maximum allowable power dissipation at any ambient temperature is calculated using: P(MAX) = (TJ(MAX) - TA) θJA. Exceeding the maximum allowable power dissipation will result in excessive die temperature, and the regulator will go into thermal shutdown. The θJA of the MIC5205-xxBM5 (all versions) is 250oC/W mounted on a PC board. Note 2: Output voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature range. Note 3: Regualtion is measured at constant junction temperature using low duty cylce pulse testing. Parts are tested for load regualtion in the load range for 0.1mA to 150mA. Note 4: Dropout Voltage is defined as the input to output differential at which the output voltage drops 2% below its normal value measured at 1V differential. Note 5: Ground pin current is the regulator quiescent current plus pass transistor base current. The total current drawn from the supply is the sum of the load current plus the ground pin current. Note 6: Thermal regulation is defined as the change in output voltage at a time T after a change in power dissipation is applied, excluding load or line regulation effects. Specifications are for a 150mA load pulse at VIN = 16V for T = 10ms. Information furnished by Calogic is believed to be accurate and reliable. However, no responsibility is assumed for its use: nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent rights of Calogic. CALOGIC CORPORATION, 237 Whitney Place, Fremont, California 94539, Telephone: 510-656-2900, FAX: 510-651-3025