EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 Ecn: Page:1of8 MODEL NO: ITR8105 ■ Package Dimensions : DESIGNER CHECKER APPROVED Office: NO 25,Lane 76,Chung Yang Rd,,Sec.3 Tucheng, Taipei 236,Taiwan, R.O.C. TEL: 886-2-2267-2000,2267-9936(22Lines) FAX: 886-2-2267-6189 04/07/22 09:08 AM 1 8105.doc EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 Ecn: Page:2of8 MODEL NO: ITR8105 ◎Notes： 1.All dimensions are in millimeter. 2.General Tolerance:±0.2mm 3.Lead spacing is measured where the lead emerge from the package. 4.Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 5.These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s consent. 6.When using this product , please observe the absolute maximum ratings and the instructions for use outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. ■ Descriptions: The ITR8105(Slot Optical Switch) is a gallium arsenide infrared emitting diode which is coupled with a silicon photo transistor in a plastic housing. The packaging system is designed to optimizes the mechanical resolution, coupling efficiency, and insulates ambient light. The slot in the housing a provides a means of interrupting the signal with printer, scanner, copier, or other opaque material, switching the output from an ” ON” to” OFF” state. ■ Features: ．Wide gap between light emitter and detector(2.6mm) ．High sensing accuracy ．PWB mounting type package Pb free ■ Applications: ．Copier ．Printer ．Facsimile ．Ticket vending machine ．Opto-electronic switch 04/07/22 09:08 AM 2 8105.doc EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 Ecn: Page:3of8 MODEL NO: ITR8105 ■ Absolute Maximum Ratings (Ta=25ºC) Parameter Symbol Ratings Unit Pd 75 mW Input Reverse Voltage VR 5 V Forward Current IF 50 mA IFP 1 A PC 75 mW IC 20 mA Collector-Emitter Voltage VCEO 30 V Emitter-Collector Voltage VECO 5 V Operating Temperature Topr -25~+85 ºC Storage Temperature Tstg -40~+85 ºC Lead Soldering Temperature (1/16 inch from body for 5 seconds) Tsol 260 ºC Power Dissipation at(or below) 25℃ Free Air Temperature Peak Forward Current Pulse width ≦100μs, Duty cycle=1% Collector Power Dissipation Output Collector Current ■ Electro-Optical Characteristics (Ta=25ºC) Parameter VF - 1.2 1.6 V IF=20mA Reverse Current IR - - 10 µA VR=5V Peak Wavelength λP - 940 - nm IF=20mA 2 1/2 - 60 - Deg IF=20mA Collector Dark Current ICEO - - 100 nA VCE=10V C-E Saturation Voltage VCE(sat) - - 0.4 V IC=0.5mA IF=20mA IC(ON) 1 4 15 mA tr - 20 - µsec tf - 20 - µsec View Angle Transfer Collector Current Characteristic Rise time Fall time 04/07/22 09:08 AM Condition Forward Voltage Input Output Symbol Min. Typ. Max. Unit 3 VCE=5V IF=10mA VCE=5V IC=1mA RL=1KΩ 8105.doc EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 Ecn: Page:4of8 MODEL NO: ITR8105 ■ Typical Characteristics For IR 04/07/22 09:08 AM 4 8105.doc EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 Ecn: Page:5of8 MODEL NO: ITR8105 ■Typical Characteristics For PT ■Typical Characteristics For ITR 04/07/22 09:08 AM 5 8105.doc EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 Ecn: Page:6of8 MODEL NO: ITR8105 ■Reliability test item and condition The reliability of products shall be satisfied with item listed below: Confidence level :90% LTPD:10% Parameter Temperature Cycle Purpose & Condition Failure Judgement Criteria Evaluates product's ability IR≧U x 2 to withstand exposure to Samples(n) Defective(c) n =22，c=0 Ic(on)≦L x 0.8 high temperature, low VF≧U x 1.2 temperature, and temperature variation between two limit temperature. Standard test Condition: 85ºC ~25ºC ~-55ºC ~25ºC 30min Thermal Shock 5min 30min 50 cycle 5min Evaluates product's ability to U：Upper specification limit L：Lower specification limit n =22，c=0 withstand rapid temperature change Standard test Condition: 85ºC ~ -55ºC 5min 5min 50cycle High Temperature Evaluates product's ability to Storage withstand prolonged storage n =22，c=0 at high temperature Standard test Condition: Temperature : 100 ºC Time : 1000hrs Low Temperature Storage Evaluates product's ability to withstand prolonged storage at low temperature Standard test Condition: n =22，c=0 Temperature : -55 ºC Time : 1000hrs 04/07/22 09:08 AM 6 8105.doc EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 MODEL NO: ITR8105 Ecn: Page:7of8 Failure Samples(n) Judgement Parameter Purpose & Condition Defective(c) Criteria Operating Life Test Evaluates product's endurance n =22，c=0 I ≧U x 2 R to prolonged electrical or Ic(on)≦L x 0.8 temperature stresses. Standard VF≧U x 1.2 test Condition: VCE=5V IF=20mA Time : 1000hrs High Temperature U：Upper specification limit Evaluates product's ability to withstand prolonged storage High Humidity n =22，c=0 L：Lower specification limit at high temperature and high humidity. Standard test Condition: Temperature: 85ºC Relative humidity:85% Time : 1000hrs Soldering Heat Evaluates product's ability to n =22，c=0 withstand soldering heat Standard test conditions Solder temperature : 260±5ºC Solder time : 10 seconds ■Supplements 1.Parts (1) Chip Type IR PT Material GaAs or GaAlAs Silicon Peak Wavelength 940 nm 860 nm (2)Material Type Material 04/07/22 09:08 AM Lead frame SPCC Wire Gold 7 Part Package Epoxy Holder ABS 8105.doc EVERLIGHT ELECTRONICS CO., LTD. Device Number: DRX-081-003 REV: 1.1 Ecn: Page:8of8 MODEL NO: ITR8105 ■Packing Specifications CPN : Customer’s Product Number P/N : Product Number QTY : Packing Quantity CAT : Ranks HUE : Peak Wavelength REF : Reference LOT NO : Lot Number MADE IN TAIWAN : Production place ■Packing Quantity Specification 1.150Pcs/1Bag，4Bags/1Box 2.10Boxes/1Carton 04/07/22 09:08 AM 8 8105.doc