ETC LCM1210R2

LCM1210R2
Molded
Chip Inductor
.098" ± .012"
2.50mm ± .3
.126" ± .012"
3.20mm ± .3
.086" ± .012"
2.20mm ± .3
.020" ± .008"
.5 mm
FEATURES
.067" ±.003"
1.7 mm
APPLICATIONS
Small molded chip inductor
TV's, VCR's, and audio equipment
Special ferrite core ensures stable inductance against
temperature humidity
Disk drives and other computer periferals
Broad inductance range
Personal computers
Electronic control boards for automobiles
High Q
Telecommunication devices
Highly reliable
Excellent for flow, re-flow soldering, and soldering iron
CHARACTERISTICS
INDUCTANCE RANGE .01 µH to 330 µH
TOLERANCE 10% over entire range. 5% available upon request
CURRENT RATING Based on current flow and temperature rise of 20°C maximum at 80°C ambient temperature.
TESTING PROCEDURE Inductance, Q, and SRF measured by HP4191A Impedance Analyzer with 16092A Test Clip at specified
frequency. DCR measured with digital milliohms meter.
DIELECTRIC STRENGTH 1000 volts DC between both terminals and package of coil for 5 seconds.
SOLDERABILITY
95% of the terminal is covered with solder. Please refer to page 2 for soldering recommendations.
SOLDERING HEAT: RESISTANCE
TEMPERATURE CHARACTERISTIC
260°C for 10 seconds after 120°C preheat cycle for 5 minutes.
-25°C to 85°C where inductance and Q shall not change more than 20%.
STORAGE TEMPERATURE Store at normal temperature (-5°C to + 35°C) and normal humidity(85% RH max) inoriginal package.
Do not expose to direct sunlight or harmful gas. This inductor can maintain its characteristics in a storage temperature from
-40°C to + 125°C for a period of 90 days.
HUMIDITY CHARACTERISTICS There is no change in performance at a humidity condition of 90-95% RH in 500 hours.
Measurement shall be made after 1 hour stabilization at room temperature.
HEAT RESISTANCE Subjected to 100°C for 1000 hours without change in appearance, deformation, or perf ormance.
Measurement shall be made after 1 hour stabilization at room temperature.
THERMAL SHOCK Subjected to 100 cycles at the following temperature range without a change in performance: -25°C for
1 hour + 100°C for 1 hour. Measurement shall be made after 1 hour stabilazation at room temperature.
TERMINAL STRENGTH
Meets 3 lbs. pull test
RESISTANCE TO SOLVENT No change in appearance when dipped into alcohol or freon for 3 minutes.
MARKING
Part is mar ked with inductance value in EIA code.
PACKAGING
Tape and Reel only.