1.25Gbps MM Optical Transceiver Module (5V) Part Number：P5H6RS3727 1. Description The P5H6RS3727 transceiver module uses 850nm VCSEL and high-speed/quality PIN-TIA for fiber cable 62.5/125um MMF fiber optical system and link distance up to 550m. The module supplies the differential PECL +5.0V and provides system designer with products to implement a range of Gigabit Ethernet/IEEE Draft P802.3z and DataCommunication Networks. The module was all supplied in the new industry standard 1x9 SIP package style with a duplex SC connector interface.. I /O Description Data Input ：PECL compatible differential data Input to laser diode ：PECL compatible differential output of limiting amplifier Signal Output Alarm Function ：Signal Detect(SD) 2. Acronyms z SD Signal Detect z BER Bit Error Rate z TIA Transimpedance Amplifier z BOL Beginning Of Life z EOL End Of Life z PECL Positive Emitter Coupler Logic z PRBS Pseudo Random Bit Sequence z LDD Laser Diode Driver APAC Opto reserves the right to modify products and specifications without prior notice 7 San-Min Road, Hsinchu Industrial Park, Hukow, Hsinchu Hsien, Taiwan 303 Tel：+886-3-5986799 Fax：+886-3-5986655 www.apacoe.com.tw [email protected] Page 1 2002-02-22 Ver A 1.25Gbps MM Optical Transceiver Module (5V) 3. Related documents z GR-253. CORE Issue 2. Rev 2. Jan 1999 - SONET Requirements z IEEE Draft P802.3z Requirements 4. Electro-Optical Specification All specifications apply to an operating range of 0℃ to + 70℃ unless otherwise stated. All optical powers are mean unless otherwise stated. 4.1 Absolute Maximum Ratings If any of parameters below are exceeded, the performance specified in section 4.2 cannot be guaranteed. Parameter Symbol Storage Temperature Operating Temp. Supply Voltage Lead Soldering(Temperature) Lead Soldering(Time) Tstg Top Vo Stemp Stime MIN. -40 0 4.75 Values TYP. MAX. 85 70 5.25 260 10 Unit ℃ ℃ V ℃ Sec 4.2 Operating Characteristics All parameters are EOL and apply over the ambient temperature -40℃ to + 85℃. 4.2.1 Electro-Optical Interface Transmitter Side Tc=0℃ to 70℃,Vcc=4.75 to 5.25V, Vee = GND , unless otherwise specified. Parameter Output Optical Power Optical Extinction Ratio Eye Diagram Optical Rise Time(20~80%) Optical fall Time(80~20%) Center Wavelength Spectral Width (RMS) Symbol Condition Po Er *Note1 *Note1 TR TF λ △λ *Note2 *Note2 Values MIN. TYP. MAX. -9.5 -5 9 IEEE Draft P802.3z 260 260 830 860 0.85 Unit dBm dB psec psec nm nm *Note1：Measured at the end of 100m length 62.5/125um step index fiber cable using 1.25Gbps,PRBS 27-1. Signal at the beginning of life *Note2：Measured using 1.25Gbps 1010 signal APAC Opto reserves the right to modify products and specifications without prior notice 7 San-Min Road, Hsinchu Industrial Park, Hukow, Hsinchu Hsien, Taiwan 303 Tel：+886-3-5986799 Fax：+886-3-5986655 www.apacoe.com.tw [email protected] Page 2 2002-02-22 Ver A 1.25Gbps MM Optical Transceiver Module (5V) Receiver Side Tc=0℃ to 70℃,Vcc=4.75 to 5.25V, Vee=GND, unless otherwise specified. Parameter Optical Input Wavelength Sensitivity (Input Power) SD Assert Level SD Deassert Level SD Hysteresis Symbol Condition λ Pin Pa Pd Phys *Note1 *Note2,3 *Note2 *Note2 MIN. 770 -18 -29 0.5 Values TYP. 1.5 MAX. 860 -3 Ps+0.5 6 Unit nm dBm dBm dBm dB *Note1：BER=1×10-12,1.25Gbps,PRBS 27-1 *Note2：1.25Gbps, 1010 signal *Note3：Ps at different sensitivity level 4.2.2 Electrical Interface Transmitter Side Tc=0℃ to 70℃,Vcc=4.75 to 5.25V, Vee=GND, unless otherwise specified. Parameter Symbol Supply Voltage Supply current Input Voltage (High) Input Voltage (Low) Rise Time Input Signal Fall Time Input Signal VCCTX Is VIH VIL TRIN TFIN Condition *Note1 *Note1 *Note2 *Note2 MIN. 4.75 Values TYP. 5 MAX. 5.25 150 VCCTX-1.17 VCCTX-0.73 VCCTX-1.95 VCCTX-1.45 260 260 Unit V mA V V psec psec *Note1：VCCTX =5.0 V , Tc=25℃ *Note2：20%~80% Receiver Side Tc=0℃ to 70℃,Vcc=4.75 to 5.25V, Vee=GND, unless otherwise specified. Parameter Supply Voltage Supply Current Output Voltage (High) Output Voltage (Low) Rise Time Output Signal Fall Time Output Signal Symbol Condition VCCRX Is VOH VOL TROUT TFOUT *Note1 *Note2,3 *Note2,3 *Note4 *Note4 MIN. 4.75 Values TYP. 5 MAX. 5.25 200 VCCRX -1.03 VCCRX -0.88 VCCRX -1.81 VCCRX -1.62 260 260 Unit V mA V V psec psec *Note1：Output currents are not included *Note2：Output load resistor(RL=50 Ω) is connected to VCCRX –2.0V *Note3：VCCRX=5V,Tc=25℃ *Note4：20~80% APAC Opto reserves the right to modify products and specifications without prior notice 7 San-Min Road, Hsinchu Industrial Park, Hukow, Hsinchu Hsien, Taiwan 303 Tel：+886-3-5986799 Fax：+886-3-5986655 www.apacoe.com.tw [email protected] Page 3 2002-02-22 Ver A 1.25Gbps MM Optical Transceiver Module (5V) 5. Mechanical Specification 5.1 Outline Drawing All dimensions are in millimeters. 5.2 Pin Locations View from the above side (i.e. through this module) PIN 1 2 3 4 5 6 7 8 9 Function Vee Rx Rx Output+ Rx OutputSD Vcc Rx Vcc Tx Tx InputTx Input+ Vee Tx APAC Opto reserves the right to modify products and specifications without prior notice 7 San-Min Road, Hsinchu Industrial Park, Hukow, Hsinchu Hsien, Taiwan 303 Tel：+886-3-5986799 Fax：+886-3-5986655 www.apacoe.com.tw [email protected] Page 4 2002-02-22 Ver A 1.25Gbps MM Optical Transceiver Module (5V) 5.3 Pin Connections PIN FUNCTION AND SIGNAL/VOLTAGE Pin Name Function Type Pin # Description RxVEE Receiver Ground Power Supply 1 Ground RXD Receiver Output Data PECL Compatible Output 2 Receiver Output Data 3 Inverted Receiver Output Data SD Receive Signal Detect PECL Output 4 High = Optical Signal Present RxVCC Transmit Power Power Supply 5 Positive Power Supply , +5V TxVCC Receive Power Power Supply 6 Positive Power Supply , +5V Transmitter Output Data PECL Compatible Output 7 Inverted Transmitter Input Data 8 Transmitter Input Data Transmitter Ground Power Supply 9 Ground RXDn TxDn TxD TxVEE NC POST 10-11 Not Connected 5.4 Flammability The component will comply with flammability rating UL94V-0. APAC Opto reserves the right to modify products and specifications without prior notice 7 San-Min Road, Hsinchu Industrial Park, Hukow, Hsinchu Hsien, Taiwan 303 Tel：+886-3-5986799 Fax：+886-3-5986655 www.apacoe.com.tw [email protected] Page 5 2002-02-22 Ver A