PA-MACH210-Q06T Data Sheet 44 pin QFP socket/28 pin DIP 0.6” plug Supported Device/Footprints Adapter Construction Using this adapter, the AMD MACH110, 210 & 215 in the QFP package can be programmed on DIP programmers. The adapter is made up of 3 sub-assemblies. They assemble via connectors making the adapter modular. This way the subassemblies can be replaced when they wear out. Mfgr AMD Device Footprint Device Package Device Plug MACH 110, QFP MACH 110, AMD spec'd 210 & 215 210 & 215 28 DIP 0.6" The QFP socket accepts packages with the dimensions listed below: When disassembling the adapter take care not to bend the pins. When reassembling the adapter note the pin 1 indicators to align the parts correctly. Test Socket Lidded QFP test socket: Enplas Part #: FPQ-44-0.8-06T LSC Part #: 44QF-06T 44QFP-6T Accepts the test socket and connects to the bottom board. MACH210 BASE Performs the wiring shown in the Adapter Wiring section. Body Knee Tip 10.0 mm typical 11.0 mm typical 12 mm typical 11.6 maximum 13.2 maximum Adapter Dimensions Pitch 0.8 mm Adapter Wiring The following chart shows the connections from the QFP device to the adapter’s DIP plug. DEVICE 39 40 41 42 43 44 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 SIGNAL GND I/O 0 10K I/O 2 10K 1/O 4 10K I/O 6 I/O 7 VPP MD0 GND CLK0 I/O 8 I/O 9 10K I/O 11 10K I/O 13 10K I/O 15 VCC PLUG 14 12 14 13 14 18 14 19 20 2 3 14 1 6 7 14 8 14 9 14 10 28 DEVICE 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 SIGNAL GND I/O 16 10K I/O 18 10K I/O 20 10K I/O 22 I/O 23 MD1 MD2 GND CLK1 1/O 24 1/O 25 10K I/O 27 10K I/O 29 10K I/O 31 VCC PLUG 14 11 14 15 14 16 14 17 21 4 5 14 27 22 23 14 24 14 25 14 26 28 VCC to GND has a 0.1uf capacitor. dapters-Plus 15 W 8th Street STE B Tracy, Ca 95376 ph.209-839-0200 fax.209-839-0235 WWW.ADAPT-PLUS.COM www.adapt-plus.com Rev 1/28/97 Page 1 of 1