10 SEGMENT BAR GRAPH ARRAY DC10EWA HIGH EFFICIENCY RED Features Description zLOW CURRENT OPERATION. The High Efficiency Red source color devices are zWIDE VIEWING ANGLE. Phosphide Orange Light Emitting Diode. zSUITABLE FOR LEVEL INDICATORS. zEXCELLENT ON/OFF CONTRAST. made With Gallium Arsenide Phosphide on Gallium zEND STACKABLE. zMECHANICALLY RUGGED. zBI-COLOR VERSION AVAILABLE. zSTANDARD : GRAY FACE, WHITE SEGMENT. zRoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAD1426 REV NO: V.3 DATE: APR/25/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: S.H.CHEN ERP:1331000008 Selection Guide Part No. DC10EWA Dice Iv (ucd) @ 10mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) WHITE DIFFUSED Description Min. Typ. 1900 9000 10 Segments Bargraph-Display Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage Operating / storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 5mm below package base. SPEC NO: DSAD1426 REV NO: V.3 DATE: APR/25/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: S.H.CHEN ERP:1331000008 High Efficiency Red DC10EWA Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD1426 REV NO: V.3 DATE: APR/25/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: S.H.CHEN ERP:1331000008