PG600R THRU PG608R GLASS PASSIVATED JUNCTION FAST SWITCHING RECTIFIER VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes P-600 FEATURES l Plastic package has Underwriters Laboratory Flammability Classification 94V-O Utilizing Flame Retardant Epoxy Molding Compound l Glass passivated junction in P600 package l 6 ampere operation at TA=60 ¢J with no thermal runaway l Exceeds environmental standards of MIL-S-19500/228 l Fast switching for high efficiency MECHANICAL DATA Case: Molded plastic, P600 Terminals: axial leads, solderable per MIL-STD-202, Method 208 Mounting position: Any Weight: 0.07 ounce, 2.1 grams MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ¢J ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. PG600R PG601R PG602R PG604R PG606R PG608R UNITS Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current @TA=60 ¢J Peak Forward Surge Current 8.3ms single half sine wave IFSM superimposed on rated load(JECEC method) Maximum Forward Voltage at 6.0A DC Maximum DC Reverse Current at Rated DC Ta=25 ¢J Blocking Voltage @ Ta=100 ¢J Maximum Reverse Recovery Time(Note 1) Typical Junction capacitance (Note 2) Typical Thermal Resistance at 0.375”(9.5mm)” lead length R £KJA Operating and Storage Temperature Range TA , TJ 50 35 50 150 NOTES: 1. Reverse Recovery Test Conditions: IF=.5A, IR=1A, Irr=.25A 2. Measured at 1 MHz and applied reverse voltage of 4.0 volts 100 70 100 150 200 140 200 400 280 400 6.0 V V V A 250 A 1.3 5.0 500 V £g A 150 150 600 420 600 250 800 560 800 500 ns 300 10.0 PF ¢J /W -55 to +150 ¢J RATING AND CHARACTERISTIC CURVES PG600R THRU PG608R trr +0.5A 0 -0.25 -1.0 NOTE:1.Rise Time = 7ns max. Input Impedance = 1 megohm. 22pF 2.Rise Time = 10ns max. SET TIME BASE FOR 50 ns/cm Source Impedance = 50 Ohms 1cm Fig. 1-REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM PEAK FORWARD SURGE CURRENT, AMPERES 6 SINGLE PHASE HALF WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD 5 4 3 2 1 0 20 40 60 80 100 120 140 160 200 150 100 50 1 180 200 AMBIENT TEMPERATURE, ¢J 2 4 6 8 10 20 40 60 80 100 NUMBER OF CYCLES AT 60Hz Fig. 2-FORWARD DERATING CURVE INSTANTANEOUS FORWARD CURRENT AMPERES AVERAGE FORWARD CURRENT, AMPERES 250 Fig. 3-PEAK FORWARD SURGE CURRENT 100 10 1.0 0.1 0.6 0.8 1.0 1.2 1.4 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE, VOLTS Fig. 4-TYPICAL FORWARD CHARACTERISTIC