DC/DC Converter TMV Series 1 Watt Features Single-in-Line Package (SIP) Isolated Single and Dual Output Models I/O-Isolation 3‘000 VDC High Efficiency up to 81% Operating Temperature – 40°C to +85°C Pin-compatible with other Manufacturers 100% Burn-in (8 h) 2 Year Product Warranty The TMV series are miniature, isolated 1 W DC/DC-converters with high isolation in a Single-in-Line package (SIP). Requiring only 1.2 cm2 board space they offer the ideal solution in many space critical applications for board level power distribution. The use of SMDtechnology makes it possible to offer a product with high performance at low cost. Models Ordercode TMV 0505S TMV 0512S TMV 0515S TMV 0505D TMV 0512D TMV 0515D TMV 1205S TMV 1212S TMV 1215S TMV 1205D TMV 1212D TMV 1215D TMV 2405S TMV 2412S TMV 2415S TMV 2405D TMV 2412D TMV 2415D www.tracopower.com Input voltage Output voltage Output current max. Efficiency typ. 5 VDC ±10% 5 VDC 12 VDC 15 VDC ± 5 VDC ±12 VDC ±15 VDC 200 mA 80 mA 65 mA ±100 mA ± 40 mA ± 30 mA 71 78 78 72 78 79 % % % % % % 12 VDC ±10% 5 VDC 12 VDC 15 VDC ± 5 VDC ±12 VDC ±15 VDC 200 mA 80 mA 65 mA ±100 mA ± 40 mA ± 30 mA 73 80 80 74 81 81 % % % % % % 24 VDC ±10% 5 VDC 12 VDC 15 VDC ± 5 VDC ±12 VDC ±15 VDC 200 mA 80 mA 65 mA ±100 mA ± 40 mA ± 30 mA 71 78 79 72 79 80 % % % % % % Page 1 DC/DC Converter TMV Series 1 Watt Input Specifications Input current no load /full load 5 Vin models 12 Vin models 24 Vin models 30 mA / 260 mA typ. 12 mA / 110 mA typ. 7 mA / 50 mA typ. Surge voltage (1 sec. max.) 5 Vin models 12 Vin models 24 Vin models 9 V max. 18 V max. 30 V max. Reverse voltage protection 0.3 A max. Reflected input ripple current* can be reduced by ext. 1–3.3 µF polyester film capacitor Input filter internal capacitor Output Specifications Voltage set accuracy ±3% Voltage balance (dual output models) ± 1 % max. Regulation ± 1.2 % / 1 % change Vin ± 10 % max. – Input variation – Load variation 20 – 100 % Ripple and noise (20 MHz Bandwidth) 100 mV pk-pk max. Temperature coefficient ± 0.02 % / °C Short circuit protection limited 1 sec. max. Capacitive load 680 µF max. 220 µF max. – Single output models – Dual output models General Specifications Temperature ranges – Operating – Case temperature – Storage – 40 °C ... +85 °C + 95 °C max. – 40 °C ... +105 °C Humidity (non condensing) 95 % rel H max. Reliability, calculated MTBF (MIL-HDBK-217 E) >2’000’000 h @ 25 °C Isolation voltage Input/Output 3‘000 VDC Isolation capacity Input/Output 60 pF typ. Isolation resistance Input/Output >10‘000 M Ohm Switching frequency 100 kHz typ. (Frequency modulation) Frequency change over line and load ± 30 % max. All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. www.tracopower.com Page 2 DC/DC Converter TMV Series 1 Watt Physical Specifications Case material non conductive black plastic (flammability to UL 94-V0) Package weight – Single output models – Dual output models 2.1 g (0.07 oz) 2.6 g (0.09 oz) Soldering temperature max. 260°C / 10 sec Outline Dimensions mm (inches) 10.2 (0.4) 3.2 (0.13) 0.5 (0.02) Pin-Out 0.5 (0.02) 2.3 ±0.4 2.54 (0.09 ±0.02) (0.1) 2.54 2.54 7.62 (0.3) (0.1) Pin Single Dual 1 +Vin (Vcc) +Vin (Vcc) 2 –Vin (GND) –Vin (GND) 5 –Vout –Vout 6 No pin Common 7 +Vout +Vout 0.5 (0.02) (0.1) 0.5 (0.02) 7.0 (0.28) 24 V Models 7 6.0 (0.24) 6 5.75 (0.23) 5 4.75 (0.19) 2 (0.05) 1 1.25 Bottom view 0.25 (0.01) 19.5 (0.77) Tolerances ±0.25 (0.01) pins ±0.05 (0.002) Specifications can be changed without notice Rev. 06/00 Jenatschstrasse 1 • CH-8002 Zurich • Switzerland Tel. +41-1284 2911 • Fax +41-1201 1168 • e-mail: [email protected] • internet: http://www.tracopower.com Page 3