ER1000F THRU ER1004F ISOLATION SUPERFAST RECOVERY RECTIFIERS VOLTAGE - 50 to 400 Volts CURRENT - 10.0 Amperes FEATURES l ITO-220AC Plastic package has Underwriters Laboratory Flammability Classification 94V-O utilizing Flame Retardant Epoxy Molding Compound l Exceeds environmental standards of MIL-S-19500/228 l Low power loss, high efficiency l Low forward voltage, high current capability l High surge capacity l Super fast recovery times, high voltage l Epitaxial chip construction MECHANICAL DATA Case: ITO-220AC full molded plastic package Terminals: Leads, solderable per MIL-STD-202, Method 208 Polarity: As marked Mounting Position: Any Weight: 0.08 ounces, 2.24 grams MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, Resistive or inductive load. For capacitive load, derate current by 20%. Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at TC=100 ER1000F ER1001F ER1001AF ER1002F ER1003F ER1004F UNITS 50 35 50 100 70 100 150 105 150 200 140 200 300 210 300 400 320 400 V Peak Forward Surge Current, 8.3ms single half sine-wave superimposed on rated load(JEDEC method) Maximum Forward Voltage at 10.0A per element Maximum DC Reverse Current at Rated Ta=25 NOTES: 1. Measured at 1 MHz and applied reverse voltage of 4.0 VDC 2. Reverse Recovery Test Conditions: IF=.5A, IR=1A, Irr=.25A 10.0 A 150 A 0.95 DC Blocking Voltage per element Ta=125 Typical Junction capacitance (Note 1) Maximum Reverse Recovery Time(Note 2) Typical Thermal Resistance(Note 3) R JC Operating and Storage Temperature Range TJ V V 1.30 A 10 500 62 35 PF 50 3.0 -55 to +150 V ns /W 3. Thermal resistance junction to CASE RATING AND CHARACTERISTIC CURVES ER1000F THRU ER1004F Fig. 1-FORWARD CURRENT DERATING CURVE Fig. 2-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTIC Fig. 4-MAXIMUM NON-REPETITIVE SURGE CURRENT Fig. 3-TYPICAL REVERSE CHARACTERISTICS Fig. 5-TYPICAL JUNCTION CAPACITANCE