Technical Data Sheet Top Phototransistor PT67-21B/C14/TR8 Features ․Fast response time ․High photo sensitivity ․Small junction capacitance ․Package in 8mm tape on 7” diameter reels. ․Compatible with infrared and vapor phase reflow solder process. ․Pb free ․The product itself will remain within RoHS compliant version. Descriptions ․PT67-21B/C14/TR8 is a high speed silicon NPN epitaxial planar phototransistor in a compact surface-mountable package. It’s compatible with automatic placement equipment and can withstand IR reflow, vapor phase reflow , and wave solder processes. Applications ․Miniature switch ․Counters and sorter ․Position sensor ․Infrared applied system Device Selection Guide LED Part No. Chip Material Lens Color PT Silicon Black Everlight Electronics Co., Ltd. Device No：DTT-067-248 http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 1 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8 Package Dimensions Collector Emitter 1.8 1.6 1.8 Notes: 1.All dimensions are in millimeters 2.Tolerances unless dimensions ±0.1mm Absolute Maximum Ratings (Ta=25℃) Parameter Symbol Rating Units Collector-Emitter Voltage VCEO 30 Emitter-Collector-Voltage VECO 5 V V IC 20 mA Operating Temperature Topr -40 ~ +100 ℃ Storage Temperature Tstg -40 ~ +100 ℃ Soldering Temperature Tsol 260 ℃ Power Dissipation at(or below) 25℃Free Air Temperature Pc 75 mW Collector Current Notes: *1:Soldering time≦5 seconds. Everlight Electronics Co., Ltd. Device No：DTT-067-248 http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 2 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8 Electro-Optical Characteristics (Ta=25℃) Parameter Symbol Condition Min Typ Max Unit Rang Of Spectral Bandwidth λ0.5 --- 700 --- 1100 nm Wavelength Of Peak Sensitivity λP --- --- 940 --- nm Collector-Emitter Breakdown Voltage BVCEO IC=100μA Ee=0mW/cm2 30 --- --- V Emitter-Collector Breakdown Voltage BVECO 5 --- --- V Collector-Emitter Saturation Voltage VCE(sat) IC=2mA Ee=1m W/cm2 --- --- 0.4 V Collector Dark Current ICEO VCE=20V Ee=0mW/cm2 --- --- 100 nA On State Collector Current IC(ON) VCE=5V Ee=0.1mW /cm2 16 --- 80 μA --- 15 --- --- 15 --- Rise Time tr Fall Time tf IE=100μA Ee=0mW/cm2 VCE=5V IC=1mA RL=1000Ω μS Rank Condition：VCE=5V, Ee=0.1mW /cm2 Unit：μA Bin Number Min Max Bin1 ≧16 ---- Everlight Electronics Co., Ltd. Device No：DTT-067-248 Bin2 16 32 Bin3 25 50 http:\\www.everlight.com Prepared date：10-27-2006 Bin4 40 80 Rev 1 Page: 3 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8 Typical Electro-Optical Characteristics Curves Fig.1Collector Power Dissipation vs. Ambient Temperature Fig.2 Spectral Sensitivity 100 1.0 O Ta=25 C 80 0.8 60 0.6 40 0.4 20 0.2 0 -40 0 25 50 75 100 125 Fig.3 Relative Collector Current vs. Ambient Temperature 0 600 700 800 900 1000 1100 1200 Fig.4 Collector Current vs. Irradiance 200 160 C 2 140 150 120 100 100 80 60 40 50 20 0 0 0 10 20 30 40 50 60 70 0.01 0.1 1 10 2 Everlight Electronics Co., Ltd. Device No：DTT-067-248 http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 4 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8 Typical Electro-Optical Characteristics Curves Fig.5 Collector Dark Current vs. Ambient Temperature Fig.6 Collector Current vs. Collector-Emitter Voltage 10 14 12 10 10 8 10 6 4 10 2 10 0 25 50 Everlight Electronics Co., Ltd. Device No：DTT-067-248 75 100 0 0 http:\\www.everlight.com Prepared date：10-27-2006 1 2 Rev 1 3 Page: 5 of 10 Prepared by：JAINETSAI 4 PT67-21B/C14/TR8 Precautions For Use 1. Over-current-proof Customer must apply resistors for protection , otherwise slight voltage shift will cause big current change ( Burn out will happen ). 2. Storage 2.1 Do not open moisture proof bag before the products are ready to use. 2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less. 2.3 The LEDs should be used within a year. 2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less. 2.5 The LEDs should be used within 168 hours (7 days) after opening the package. 2.6 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the storage time, baking treatment should be performed using the following conditions. Baking treatment : 60±5℃ for 24 hours. 3. Soldering Condition 3.1 Pb-free solder temperature profile 3.2 Reflow soldering should not be done more than two times. 3.3 When soldering, do not put stress on the LEDs during heating. 3.4 After soldering, do not warp the circuit board. Everlight Electronics Co., Ltd. Device No：DTT-067-248 http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 6 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8 4.Soldering Iron Each terminal is to go to the tip of soldering iron temperature less than 280℃ for 3 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder. 5.Repairing Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Everlight Electronics Co., Ltd. Device No：DTT-067-248 http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 7 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8) Reliability Test Item And Condition The reliability of products shall be satisfied with items listed below. Confidence level：90% LTPD：10% NO. Item 1 REFLOW Test Conditions Test Hours/ Sample Cycles Sizes TEMP.：260℃±5℃ 6Mins 5secs 2 Temperature Cycle H : 100℃ L : -40℃ 3 Thermal Shock Failure Judgement Criteria Ac/Re 22pcs 0/1 15mins 50Cycles 5mins 15mins 22pcs 0/1 5mins 50Cycles 10secs 5mins 22pcs H :+100℃ L :-10℃ IC(ON)≦L×0.8 L：Lower 0/1 Specification Limit 4 High Temperature Storage TEMP.：+100℃ 1000hrs 22pcs 0/1 5 Low Temperature Storage TEMP.：-40℃ 1000hrs 22pcs 0/1 1000hrs 22pcs 0/1 1000hrs 22pcs 0/1 6 DC Operating Life VCE=5V 7 High Temperature/ 85℃ / 85% R.H High Humidity Everlight Electronics Co., Ltd. Device No：DTT-067-248 http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 8 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8 Package Dimensions Loaded Quantity Per Reel 2000PCS/Reel Collector Emitter Everlight Electronics Co., Ltd. Device No：DTT-067-248 http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 9 of 10 Prepared by：JAINETSAI PT67-21B/C14/TR8 Packing Quantity Specification 1.2000Pcs/1Volume，1Volume/1Bag 2.10Boxes/1Carton Label Form Specification CPN: Customer’s Production Number P/N : Production Number QTY: Packing Quantity CAT: Ranks HUE: Peak Wavelength REF: Reference LOT No: Lot Number MADE IN TAIWAN: Production Place RoHS PT67-21B/C14/TR8 Notes 1. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. 3. These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s consent. EVERLIGHT ELECTRONICS CO., LTD. Office: No 25, Lane 76, Sec 3, Chung Yang Rd, Tucheng, Taipei 236, Taiwan, R.O.C Everlight Electronics Co., Ltd. Device No：DTT-067-248 Tel: 886-2-2267-2000, 2267-9936 Fax: 886-2267-6244, 2267-6189, 2267-6306 http:\\www.everlight.com http:\\www.everlight.com Prepared date：10-27-2006 Rev 1 Page: 10 of 10 Prepared by：JAINETSAI