Dye Sensitised Indoor Photovoltaic Module E Indy4100 data sheet rlong =100mm F N.B.Image not to scale X I L E B L rlat = +/-1.0mm 61mm +1.0mm -1.0mm Parameter Symbol Open circuit voltage Voc Short circuit current Isc Operating voltage Vop Operating current Iop Bend radius Br Thickness d Mass M 100mm + ve Power connections are suitable for crimp connection or soldered _ ve connection with the appropriate use of heat-shunt tweezers to ensure minimal heating of the polymer material. Condition Typical Minimum Maximum 200 lux 2.24 2.17 2.31 1000 lux 2.50 2.45 2.55 200 lux 109 105 113 1000 lux 524 498 551 200 lux 1.81 1.74 1.89 1000lux 2.03 1.96 2.09 Units V µA V 200 lux 97 93 101 1000 lux 476 454 497 - 30 - - mm - 0.35 - - mm 0.06 µA gcm-2 F36W-827 Fluorescent tubes G24i’s dye sensitised indoor photovoltaic modules have been optimised to work under indoor lighting providing the highest power density. This evaluation module is intended for development, demonstration or evaluation purposes only. G24i does not provide this module as a finished product fit for general use. Persons handling the module must have electronics training and observe good engineering practice standards. G24i reserves the right to change the module specification at any time. N.B. All dimensional measurements shown are approximate. Performance specifications shown maybe subject to variation. Physical Characteristics maybe subject to change. Longitudinal bend radius spec (rlong) Lateral bend radius spec (rlat) All samples supplied are prototype subject to customer specification. G24 Innovations Ltd, Wentloog Environmental Centre, Cardiff, UK, CF3 2GH Tel:+44 (0) 2920 837 340 www.g24i.com G0090; Iss02 For all prototype samples e-mail: [email protected]