Xeon H Power Red LED OSR5XMEHC1E VER C.0 ■Features ■Outline Highest luminous flux ● Super energy efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance Anode(+) 1.15 ● Dimension 3.6 2.0 Cathode(-) BackView ■Applications ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext 0.1 (Ta=25℃) Unit DC Forward Current IF 200 mA Pulse Forward Current* IFP 250 mA Reverse Voltage VR 5 V Power Dissipation PD 600 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 1.05 0 0 Duty ratio max 1/10 Symbol VF Condition IF=150mA ■Forward Operating Current (DC) (Ta=25℃) Min. 2.0 Typ. 2.5 Max. Unit 3.0 V DC Reverse Current IR VR=5V - - 10 µA Domi. Wavelength λD IF=150mA 620 625 630 nm Luminous Flux Φv IF=150mA 15 20 - lm 50% Power Angle 2θ1/2 IF=150mA - 120 - deg 200 Forward Current, IF (mA) ■Electrical -Optical Characteristics DC Forward Voltage ESD Protection Diode Unit:mm Tolerance:±0.30mm ■Directivity Value Item 0.2 14.5 Symbol *Pulse width Max.10ms Cathode 5.3 Anode ■Absolute Maximum Rating Item 2.75 5.0 175 150 125 100 RJ-A=70℃ /W RJ-A=90℃/ W RJ-A=110 ℃ /W 75 50 25 0 0 25 50 75 100 125 Ambient Temperature, T A (℃ ) Note: Don’t drive at rated current more than 5s without heat sink for Xeon H emitter series. LED & Application Technologies http://www.optosupply.com VER C.0 Xeon H Power Red LED OSR5XMEHC1E VER C.0 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER C.0