Xeon 3 Power Red LED OSR5XNE3C1E VER C.2 ■Features ■Outline Highest Luminous Flux ● Super energy efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance Anode(+) 1.15 ● Dimension 3.6 2.0 Cathode(-) BackView ■Applications 5.5 Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext 5.5 0.2 ■Directivity Value Unit DC Forward Current IF 800 mA Pulse Forward Current* IFP 1000 mA Reverse Voltage VR 5 V Power Dissipation PD 2400 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 0 0 Duty ratio max 1/10 Symbol VF ■Forward Operating Current (DC) (Ta=25℃) Condition Min. Typ. Max. Unit IF=350mA 2.0 2.3 3.0 V IF=700mA 2.5 2.8 3.5 V DC Reverse Current IR VR=5V - - 10 µA Domi. Wavelength λD IF=700mA 620 625 630 nm Luminous Flux Φv IF=700mA 70 80 - lm 50% Power Angle 2θ1/2 IF=700mA - 120 - deg 800 Forward Current, IF (mA) ■Electrical -Optical Characteristics DC Forward Voltage 1.05 0.1 (Ta=25℃) Symbol Item Cathode Unit:mm Tolerance:±0.30mm 14.5 ■Absolute Maximum Rating *Pulse width Max.10ms Anode 3.0 ● Item Anode 700 600 500 400 300 200 100 RJ-A=30℃/W RJ-A=25℃/W RJ-A=20℃/W RJ-A=15℃/W 0 0 25 50 75 100 125 Ambient Temperature, TA (℃) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series. LED & Application Technologies http://www.optosupply.com VER C.2 Xeon 3 Power Red LED OSR5XNE3C1E VER C.2 ■ Soldering Heat Reliability : Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies http://www.optosupply.com VER C.2