SM220FL ~ SM2100FL Voltage 20 ~ 100 V 2.0 Amp Schottky Barrier Rectifiers Elektronische Bauelemente RoHS Compliant Product A suffix of “-C” specifies halogen & lead-free FEATURES SOD-123FL Low forward surge current Ideal for surface mounted applications Low leakage current A MECHANICAL DATA F B Case: JEDEC SOD-123FL, molded plastic over passivated chip Terminals: Solder Plated, solderable per MIL-STD-750, Method 2026 Polarity: Color band denotes cathode end Mounting position: Any G C E D MARKING Product Marking Code Product Marking Code SM220FL 2S SM260FL 6S SM230FL 3S SM280FL 8S SM240FL 4S SM2100FL REF. AS Millimeter Min. Max. Millimeter Min. Max. REF. A 2.70 2.90 E 0.10 0.30 B 1.80 2.00 F 0.80 1.20 C 1.55 1.25 G 0.35 0.85 D 3.50 3.90 PACKAGE INFORMATION Package MPQ Leader Size SOD-123FL 2.5K 7’ inch MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (Rating 25°C ambient temperature unless otherwise specified. Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, de-rate current by 20%.) Part Number Parameter Symbol Maximum Recurrent Reverse Voltage Unit SM 220FL SM 230FL SM 240FL SM 260FL SM 280FL SM 2100FL VRRM 20 30 40 60 80 100 V Maximum RMS Voltage VRMS 14 21 28 42 56 70 V Maximum DC Blocking Voltage VDC 20 30 40 60 80 100 V VF 0.50 Maximum Instantaneous Forward Voltage @ IFM = 2.0A Maximum Average Forward Rectified Current @ TJ = 90°C Peak Forward Surge Current8.3ms single half sine-wave superimposed on rated load (JEDEC method) Maximum DC Reverse Current at Rated DC Blocking Voltage 0.55 0.72 0.85 V I(AV) 2.0 A IFSM 40 A IR 0.3 mA Typical Junction Capacitance CJ 30 pF Operating Temperature Range TJ -55~125 °C TSTG -55~150 °C Storage Temperature Range Notes： http://www.SeCoSGmbH.com/ 1. Any changes of specification will not be informed individually. Measured at f=1.0MHz, VR=4.0V 16-May-2011 Rev. A Page 1 of 2 SM220FL ~ SM2100FL Elektronische Bauelemente Voltage 20 ~ 100 V 2.0 Amp Schottky Barrier Rectifiers CHARACTERISTIC CURVES http://www.SeCoSGmbH.com/ 16-May-2011 Rev. A Any changes of specification will not be informed individually. Page 2 of 2