PROGRAMMABLE CRYSTAL OSCILLATOR AP2S Pb RoHS Compliant 2.5 x 2.0 x 0.9mm | | | | | | | | | | | | | | | FEATURES: • Performance comparable to fixed frequency oscillator • Lowest peak-to-peak jitter • Low supply current • Short lead time • Suitable for mass production • Alternative to long lead-time XO's For Small Quantities, Delivery Time is 1-5 days ELECTRICAL SPECIFICATIONS: 3.3V, 2.5V, 1.8V OPERATION Characteristics Frequency Range 3.3V 2.5V 1.8V Operation Temp. Range * (See Options) Frequency Stabilty Over Operating Temp * (See Options) Input Voltage (Operating Vdd) 3.3V 2.5V 1.8V Input Current 3.3V 2.5V 1.8V Output Type Output Load "0" level "1" level Symmetry Standby Current Rise Time (10%->90% Vdd) Fall Time (90%->10% Vdd) Unit MHz MHz MHz °C Minimum 1 1 1 -10 Typical ----- Maximum 110 90 75 60 ppm V V V mA mA mA -100 2.97 2.25 1.62 ---- -3.3 2.5 1.8 ---- 100 3.63 2.75 1.98 25 15 10 pF V V % uA nSec nSec Tri-state Function (Input to pin 1) Jitter peak-to-peak** pSec CMOS --15 --3.3V = 0.33, 2.5V = 0.25, 1.8V = 0.18 --3.3V = 2.97, 2.5V = 2.25, 1.8V = 1.62 55 45 50 --10 -2.5 ---2.5 pin 1 : High or Open , pin 3 : Enable pin 1 : Low , pin 3 : Disable --30 to 70 OPTIONS & PART IDENTIFICATION: (Left blank if standard) Supply Voltage Blank* 3.3 V 1 2.5 V 2 1.8 V *3.3V : Standard AP2S -Frequency- - - Operating Temp. 0°C to +50°C I -10°C to +60°C D -20°C to +70°C E -30°C to +70°C F -30°C to +85°C N -40°C to +85°C L Freq. Stability ±10ppm Y(*) ±20ppm J(**) ±25ppm R ±30ppm K ±35ppm H ±40ppm B ±50ppm C PIN 1(Option) OE **B PDB **Blank Packaging B Bulk T Tape and Reel Ask for Tube Package * Available for 0°C to +50°C and -10°C to +60°C only. ** Contact ABRACON for -40°C to +85°C. ** OE: Tri-state the output buffer. ** PDB: Tri-state the output buffer and shut off the oscillator, <10µA when PDB enabled. ABRACON IS ISO 9001 / QS 9000 CERTIFIED Revised: 3.5.07 30332 Esperanza, Rancho Santa Margarita, California 92688 tel 949-546-8000 | fax 949-546-8001 | www.abracon.com PROGRAMMABLE CRYSTAL OSCILLATOR AP2S Pb RoHS Compliant 2.5 x 2.0 x 0.9mm | | | | | | | | | | | | | | | TEST CIRCUIT: OUTLINE DRAWING: PIN #1 #2 CONNECTION STAND-BY / OE GND/CASE #3 #4 OUTPUT VDD Note: It is recommended to use an approximately 0.01uF bypass capacitor between PIN 2 and 4. Dimensions: inch (mm) (mm) Dimensions: Inches TAPE & REEL: Dimensions: mm ABRACON IS ISO 9001 / QS 9000 CERTIFIED Revised: 3.5.07 30332 Esperanza, Rancho Santa Margarita, California 92688 tel 949-546-8000 | fax 949-546-8001 | www.abracon.com