PCM-9388 NEW Audio 3.5" SBC with Intel® Celeron® M, VGA, LCD, LAN , USB, ISA Features 18bit TTL 2x 24bit LVDS 5VSB Supports Intel® Celeron® M processor Supports for 18-bit TTL/36-bit LVDS (48-bit LVDS optional) GPIO Power input SATA PC/104 CF Dual independent display by CRT + LVDS/CRT + TTL Fanless support with low profile heatsink Supports Embedded Software API and Utility USB2.0 COM2 LPT Shared with FDD Software APIs: GPIO RS232 LAN Watchdog Backlight On/Off SMBus CPU Speed System Throttling Utility: Reset button HDD/Power LED KB/MS H/W Monitor BIOS flash Monitoring VGA Specifications Processor System Memory SSD Coastline I/O Internal I/O EIDE Expansion Slot Ethernet Display Environment CPU Front Side Bus L2 Cache Chipset BIOS Technology Max. Capacity Socket CompactFlash VGA COM RJ-45 K/B, Mouse LPT FDD RS-232 RS-232/422/485 K/B Mouse USB Audio IrDA GPIO SMBus Mode Channel PC/104 Speed Controller Interface Controller VRAM TTL LCD LVDS LCD Dual Independent Display Operating Temperature Operating Humidity Power Type Power Supply Voltage Power Watchdog Timer Physical Characteristics Power Consumption Power Management Battery Output Interval Dimensions (L x W) Weight Intel Celeron M 600 MHz Intel Celeron M 1 GHz 400 MHz 400 MHz 512 KB 852GM + ICH4 852GM + ICH4 Award 4 Mbit Award 4 Mbit DDR 266 MHz 1 GB 1 x 200-pin SODIMM Card Type I/II 1 1 1 1 1 (share with FDD) 1 (share with LPT) 1 2 x USB 2.0 AC97, Line-in, Line-out, Mic-in 115 kbps 8-bit general purpose input/output Supported UDMA 33 1 1 10/100 Mbps Realtek RTL 8100CL 1 x RJ-45 Intel 852GM Optimized Shared Memory Architecture up to 64 MB system memory 1 x 18-bit TTL 1 x 36-bit LVDS (48-bit LVDS optional) CRT+LVDS, CRT+TTL 0 ~ 60° C (32 ~ 140° F) 0% ~ 90% relative humidity, non-condensing AT / ATX ATX: +5 V ± 5%, ±12 V ± 5% AT: 5V only to boot up (12 V is optional for LCD inverter and add on card) Typical (WinXP Idle Mode): 1.56 A @ 5 V, 0.16 A @ 12 V (Celeron M 600/DDR 256 MB) Max (Test in HCT): 2.11 A @ 5 V, 0.17 A @ 12 V (Celeron M 600/DDR 256 MB) APM, ACPI S1, S5 3 V / 210 mAH System reset Programmable 1 ~ 255 sec 146 x 102 mm (5.7" x 4") 0.85 kg (1.87 lb) Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009 PCM-9388 Board Diagram Celeron M 400MHz PSB TTL Connector Analog RGB CRT Connector DDR200/DDR266 DDR SDRAM 200pin SODIMM x 1 NS_DS90CF384 Intel GMCH (852GM) LVDS Connector Audio Connector ALC203 AC97 CODEC SATA Connector ACARD ARC772N PCI BUS Intel ICH4 IT8888G PC104 Connector 10/100 (8100CL) LAN Connector Secondary IDE Connector USB Connector USB 2.0 x 4 CompactFlash LPC Bus FWH GPIO COM1/COM2 IRDA LPT LPC Super I/O (W83627HF) Watchdog PS/2 KB&MS Ordering Information Part No. CPU PCM-9388F-M0A1E PCM-9388F-S0A1E PCM-9388SF-S0A1E PCM-9388Z-512S0A1E Celeron M 600 MHz (512 KB) Celeron M 1 GHz (0 KB) Celeron M 1 GHz (0 KB) Celeron M 1 GHz (0 KB) CRT LVDS TTL LAN IDE/SATA USB RS-232 RS-232/442/485 LPT CF PC/104 Thermal Solution Operating Temp. 1 1 1 1 FE 1 IDE 2 1 1 1 1 1 Passive 0 ~ 60° C 1 1 1 1 1 1 1 1 1 1 FE 1 FE 1 FE 1 IDE 1 SATA 1 SATA 2 2 2 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 Passive Passive Passive 0 ~ 60° C 0 ~ 60° C -20 ~ 80° C Packing List Part No. 1701440504 1700060202 1701140201 1700260250 1703100152 1703100121 Description IDE cable (44p/44p/40p) KB/MS cable RS232/422/485 cable Parallel port cable Audio cable USB cable (2 ports) Optional Items Quantity 1 1 1 1 1 1 Part No. 1703200201 1700001531 Description ATX power cable LPT to FDD cable Online Download www.advantech.com/products Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control GPIO SMBus I2C Monitor General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel® Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control. Display Watchdog Hardware Monitor Hardware Control A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds. The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage. The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness. Power Saving Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading. The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. System Throttling Backlight Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%. Software Utilities BIOS Flash The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers’ disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. Embedded Security ID The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. Monitoring The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. eSOS The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can “Lock” SQFlash via the Flash Lock function and “Unlock” it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the “Unlock” feature. Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009