PCM-3343 DM&P Vortex86DX-1GHz PC/104 SBC, LCD, LAN, CFC, On board memory Features NEW Ultra low power, fanless DM&P Vortex86DX- 1 GHz and 256 MB on-board DDR2 memory CRT+LCD dual video outputs, 24-bit LVDS/TTL support Integrate Floating-point Unit Support 2 LAN ports in standard PC/104 96 x 90 mm dimension Supports Embedded Software APIs and Utilities Software APIs: Watchdog I2C BIOS flash eSOS Brightness GPIO Backlight On/Off Utilities: Flash Lock Embedded Security ID Specifications Processor System Memory CPU Frequency L2 Cache System Chipset BIOS Technology Max. Capacity On board memory Chipset VRAM Graphic Engine Display Ethernet LVDS CRT TTL LCD Dual Display Speed Controller Connector Watchdog Timer Storage Internal I/O Expansion Power Environment Physical Characteristics CompactFlash IDE SPI Flash USB Serial IDE KB/Mouse GPIO I2C PC/104 slot Power Type Power Supply Voltage Power Consumption (Typical: Idle in WinXPe) Power Consumption (Max, test in passmark burn-in program) Battery Operation Non-Operation Dimensions (L x W) Weight PC/104 CPU Modules DM&P Vortex86DX 1.0 GHz, support Floating point unit (FPU) 1.0 GHz 256 KB DM&P Vortex86DX- 1 GHz Award integrated 16 Mbit ROM in SOC DDR2 333 MHz SDRAM on board 512 MB On board 256 MB (512 MB support by request) SMI SM712 4 MB internal memory 62.5 MHz single clock/cycle engine (EM+) 86 MHz single clock/cycle engine (EM4+) Designed to accelerate DirectDraw Supports up to 1024 x 768 @ 24-bit LVDS LCD Panel Supports up to 1024 x 768 @ 85 Hz Supports up to 1024 x 768 @ 24 bit TFT LCD Panel CRT+TTL, CRT+LVDS 10/100 Mbps LAN1: FE LAN on Vortex86DX SOC LAN2: FE LAN RTL8100C-LF Pin header System reset Software programmable from 30.5μ sec. to 512 sec. x 2 sets Compact Flash socket(Type I/II),shared with primary IDE 1 Optional onboard 4 MB SPI Flash Disk (Support by request for boot device or storage on DOS OS) 4 x USB 2.0 3 RS-232, 1 RS-232/422/485 1 1 16-bit general purpose input/output 1 1 AT 5V only to boot up (12 V is optional for LCD inverter and add on card) 0.74 @ 5 V (Vortex86DX 1 GHz, DDR2 667 256 MB) 0.85 A @5 V (Vortex86DX 1 GHz, DDR2 667 256 MB) 3 V/210 mAH 0 ~ 60° C (32 ~ 140° F) (operation humidity: 40° C @ 85% RH non-condensing) -40° C ~ 85° C and 60° C @ 95% RH non-condensing 96 x 90 mm (3.8" x 3.5") 0.097 kg (0.214lb) PCM-3343 Board Diagram Primary Master IDE CF On board DDR 2 333 256 MB (optional to 512MB) Slave Single Channel IDE conn USB 2.0 4 USB Ports MAC + PHY DM&P Vortex86DX (1 GHz ) (256KB L2) 3 RS-232 10/100 LAN1 Pin header connector ISA PC/104 connector External SPI 1 RS-232/422/485 4 MB flash PS/2 KB&MS 16 bit GPIO SPI 16M-bit BIOS I2C conn PCI Bus VGA VGA connector 24-bit TTL connector 10/100 LAN2: RTL8100 CL-F TTL SMI SM712 TTL-LVDS Transmitter 24-bit LVDS connector Ordering Information Model CPU DM&P Vortex86DX 1 GHz DM&P Vortex86DX PCM-3343F-256A1E 1 GHz DM&P Vortex86DX PCM-3343Z-256A1E 800 MHz DM&P Vortex86DX PCM-3343Z2-256A1E 800 MHz PCM-3343L-256A1E L2 Cache 256 KB 256 KB 256 KB 256 KB Memory Onboard 256M Onboard 256M Onboard 256M Onboard 256M CRT LVDS TTL LAN USB 2.0 RS-232 RS-232 /422/485 IDE KB/MS External SPI flash Thermal Expansion solution Operation Temp - - - 1 FE 2 1 1 1 Yes - Passive PC/104 0 ~ 60° C Yes Yes 1 2 FE 4 3 1 1 Yes - Passive PC/104 0 ~ 60° C Yes Yes 1 2 FE 4 3 1 1 Yes - Passive PC/104 -20 ~ 80° C Yes Yes 1 2 FE 4 3 1 1 Yes - Passive PC/104 -40 ~ 85° C Packing List Part No. 1700060202 1703060053 1703100260 1701200220 1703040157 1700000898 1700017863 9660104000 Description PCM-3343 SBC Startup Manual Utility CD CABLE 6P-6P-6P PS/2 KB & MOUSE 20 cm PS2 Cable 6P (MINI-DIN)-6P (Wafer 2.0 mm) 6 cm USB cable 2 port 2.0 mm pitch w/ bracket 26 cm RS-232 x 2 ports 2.0mm pitch 22 cm RS-422/485 W/D-SUB COM 4P 15 cm VGA cable D-SUB 15P(F)/12P-1.25 mm 15 cm LAN cable RJ45/2 x 5P-2.0 15 cm PC/104 screw and copper post package Embedded OS Quantity Part No. WinCE 6.0 Win XPE x1 x1 x1 x1 x1 x1 x1 x1 SUSI Description 2070009536: CE 6.0 Pro PCM-3343 V1.3 ENG 2070009528: XPE WES2009 Vortex86DX V4.0 ENG 2070009529: XPE WES2009 Vortex86DX V4.0 MUI24 205E343000: SUSI 3.0 SW API for PCM-3343 B:20091209 XP Optional Accessories Part No. 1701440350 Description IDE cable 44P/44P/44P 35 cm Online Download www.advantech.com/products Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control GPIO SMBus I2C Monitor General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel® Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control. Display Watchdog Hardware Monitor Hardware Control A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds. The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage. The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness. Power Saving Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading. The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. System Throttling Backlight Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%. Software Utilities BIOS Flash The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers’ disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. Embedded Security ID The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. Monitoring The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. Industrial Motherboards eSOS The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can “Lock” SQFlash via the Flash Lock function and “Unlock” it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the “Unlock” feature.