PCM-9381 Audio 3.5" SBC with Intel® Pentium® M, VGA, LVDS, DVI, LAN, USB Features LVDS Embedded Intel® Pentium® M/Celeron® M processor Power CF (Solder side) PCI-104 Supports ECC DDR memory support Supports 36-bit LVDS (48-bit LVDS optional)/VGA +5 V and +12 V power; or single +5 V power Supports Embedded Software API and Utility SODIMM (Solder side) USB Primary IDE LCD converter DVI GPIO Software APIs: HDD LED LAN SIR COM1 COM2 KB/Mouse GPIO LPT CRT FAN USB H/W Monitor Watchdog Backlight On/Off SMBus CPU Speed System Throttling Utility: BIOS flash Monitoring Specifications Processor System Memory SSD Coastline I/O Internal I/O EIDE Expansion Slot CPU Front Side Bus L2 Cache Chipset BIOS Technology Max. Capacity Socket CompactFlash VGA COM RJ-45 USB K/B, Mouse LPT RS-232 RS-232/422/485 K/B Mouse USB Audio IrDA GPIO SMBus Mode Channel PCI-104 Speed Ethernet Display Environment Controller Interface Controller VRAM LVDS LCD Dual Independent Display Operating Temperature Operating Humidity Power Type Power Supply Voltage Power Watchdog Timer Physical Characteristics Power Consumption Power Management Battery Output Interval Dimensions (L x W) Weight Socket 478 Intel Celeron M 600 MHz 400 MHz 400 MHz depends on CPU 512 KB Intel 855GME + ICH4 Intel 855GME + ICH4 Award 4 Mbit Award 4 Mbit DDR 200/266/333 MHz 1 GB 1 x 200-pin SODIMM Card Type I/II 1 1 1 1 1 1 1 2 x USB 2.0 AC97, Line-in, Line-out, Mic-in 115 kbps, SIR, IrDA 1.0 compliant (optional) 4-bit general purpose Input/Output Supported UDMA 33 1 1 10/100 Mbps 10/100/1000 Mbps (optional) Intel 82551QM (with wake on LAN) Intel 82541PI (Gigabit) 1 x RJ-45 Intel 855GME/GMCH Optimized Shared Memory Architecture up to 64 MB system memory 1 x 36-bit LVDS (48-bit optional) CRT + LVDS, CRT + DVI, LVDS + DVI 0 ~ 60° C (32 ~ 140° F) 10% ~ 90% relative humidity, non-condensing AT / ATX ATX: +5 V ± 5%, ±12 V ± 5% AT: 5V only to boot up (12 V is optional for LCD inverter and add on card) Typical (WinXP Idle Mode): +5 V @ 3.0 A, +12 V @ 0.04 A Max (Test in HCT): +5 V @ 4.26 A, +12 V @ 0.13 A APM1.2, ACPI2.0, wake on LAN, and modem ring-in functions Lithium 3 V / 196 mAH System reset Programmable 1 ~ 255 sec 146 x 102 mm (5.7" x 4") 0.85 kg (1.87 lb), weight of total package Intel Celeron M 1 GHz 400 MHz 512 KB Intel 855GME + ICH4 Award 4 Mbit Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009 PCM-9381 Board Diagram Intel Pentium M (Banias/Dothan) 400MHz PSB DVI Connector Analog RGB CRT Connector DDR266/DDR333 DDR SDRAM 200-pin SODIMM x 1 CH7301 Intel GMCH (855GME) LVDS Connector Hub I/F 266MB/s Audio Connector PCI BUS ALC203 AC97 CODEC Primary IDE Connector Intel ICH4 (82801DB) PC104PLUS Connector 10/100/1000M (82551/82541) LAN Connector USB 2.0 x 3 CompactFlash USB Connector LPC Bus FWH COM1/COM2 GPIO IRDA LPT LPC Super I/O (W83627HF) PS/2 KB&MS Ordering Information Part No. PCM-9381F-00A2E PCM-9381F-M0A2E PCM-9381F-S0A2E CPU Socket Celeron M 600 MHz Celeron M 1 GHz (373) CRT 1 LVDS 1 DVI 1 LAN 1 FE, GbE (Option) USB 3 RS-232 1 RS-232/422/485 1 LPT 1 GPIO 2 in, 2 out IrDA optional CF 1 PCI-104 1 1 1 1 1 FE, GbE (Option) 3 1 1 1 2 in, 2 out optional 1 1 1 1 1 1 FE, GbE (Option) 3 1 1 1 2 in, 2 out optional 1 1 Packing List Part No. 9689000002 1703100152 1701440351 1703100121 1700260250 1700060202 1701140201 1700000265 Description PCM-9381 SBC Mini jumper pack Startup manual Utility CD Audio cable IDE 44 pin USB 2 port cable Parallel port cable Keyboard/mouse cable Second serial port cable ATX power cable 20P-12P cable Embedded OS Quantity 1 1 1 1 1 1 1 1 1 1 1 Part No. 2070000584 2070000585 2070000586 2070000765 2070000605 2066002300 Description Win CE 4.2 P-M Core Image, PCM-938x, 2 COM, English, V 1.10 (17.2 MB) (Optional) Win CE 4.2 P-M Pro Image, PCM-938x, 2 COM, English, V 1.10 (29.1 MB) (Optional) Win CE 4.2 P-M Plus Image, PCM-938x, 2 COM, English, V 1.10 (29.9 MB) (Optional) Image CE 5.0 Pro Plus EN for P-M with 2COM Win XPE SP2 Image, PCM-938x, English, V2.10 (440 MB) (Optional) CD SUSI Library V1.0 Optional Part No. 1700000410 1700002595 1700002532 Description CABLE DVI-26P/DF13-20-pin 20 cm cable 10-pin-1.27mm /4-pin-1.25 mm 20 cm for PCM-9381/9387 FLAT cable 14-pin / 5-pin for internal COM1 RS232 20 cm Online Download www.advantech.com/products Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control GPIO SMBus I2C Monitor General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel® Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control. Display Watchdog Hardware Monitor Hardware Control A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds. The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage. The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness. Power Saving Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading. The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. System Throttling Backlight Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%. Software Utilities BIOS Flash The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers’ disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. Embedded Security ID The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. Monitoring The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. eSOS The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can “Lock” SQFlash via the Flash Lock function and “Unlock” it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the “Unlock” feature. Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009