RoHS Power Chip Inductors Dimensions: Allied Part Number Inductance (µh) Tolerance (%) PC03015-2R2M-RC 2.2 20 PC03015-3R3M-RC 3.3 PC03015-4R7M-RC Inches (mm) DCR (Ω) IDC (A) 1 0.10 0.79 20 1 0.11 0.73 4.7 20 1 0.15 0.65 PC03015-6R8M-RC 6.8 20 1 0.20 0.77 PC03015-100M-RC 10 20 1 0.30 0.45 PC03015-150M-RC 15 20 1 0.58 0.30 PC03015-220M-RC 22 20 1 0.71 0.25 PC03015-330M-RC 33 20 1 1.10 0.20 PC03015-390M-RC 39 20 1 1.30 0.17 PC03015-470M-RC 47 20 1 1.30 0.17 PC03015-680M-RC 68 20 1 2.20 0.13 PC03015-101M-RC 100 20 1 3.50 0.10 PC03015-221M-RC 220 20 1 10.92 0.07 PC03015-122M-RC 1200 20 1 38 0.05 PC03015-152M-RC 1500 20 1 55 0.03 Test Freq. MHz, 1 V PC03015 Features • Unshielded SMD low cost design • Designed for higher current applications • Accurate and consistent dimensions for auto insertion • Excellent for use in DC-DC converter application • Also available in magnetically shielded Electrical Inductance Range: 2.2µh to 1500µh Tolerance: 20% over entire range Also available in tighter tolerances Test Frequency: (L/Q) as specified Operating Temp: -40ºC ~ +85ºC IDC: Current at which Inductance drops 10% of original value with a ∆ T= 40ºC whichever is lower. Resistance to Soldering Heat Test Method: Pre-Heat 150ºC, 1 Min. Solder Composition: Sn/Ag3.0/Cu0.5 Solder Temp: 260ºC +/- 5ºC for 10 sec ± 1 sec. Test Equipment (L & Q): HP4192A Impedence Analyzer (DCR): Chen Hwa 502BC (IDC): HP4284A with HP42841A or CH1061 with CH301A All specifications subject to change without notice. Physical Packaging: 3000 pieces per 13 inch reel. Marking: 2 Character Alpha Code 714-665-1140 ALLIED COMPONENTS INTERNATIONAL 15 REVISED 1/14/09 www.alliedcomponents.com