revision for dwg # 1PB-P2AML4 5 5 rev ch.no. - - date description original design 11/5/2007 revised by Philipp E. 1 40 mm [1.6 in] 3 max. 4 mm [.16 in] 20 mm [.8 in] 44 mm [1.7 in] 92 mm [3.6 in] 4 68 mm [2.7 in] 3 30 mm [1.2 in] ITEM 1* 2* 3* 4* 5 DESCRIPTION CAT. NO. Mushroom, 40 mm Momentary P2AM4 Rubber Gasket 2PRG1 Mounting Nut P2MN Mounting Bracket P2BRK Panel S1 S2 5** Switch Contacts S3 S4 Up tp six switch contacts can be installed. * = Push button is supplied with rubber gasket, mounting nut and mounting bracket (ITEM 1,2,3 and 4) ** = Switch Contacts must be ordered separatly unless otherwise specified: all dimensions are in millimeters third angle projection tolerance XX XX.X XX.XX ALL = = = = ±1 mm ±0.5 mm ±0.2 mm − mm This Drawing is the property of R M E T R I C 35 Royal Road Flemington, NJ 08822-6000 (908) 806-9400 Fax (908) 806-9490 and is a confidential disclosurelent without consideration other than the borrower’s agreement that it shall not be reproduced, copied, lent or disposed of directly or indirectly nor used for any purpose other than that for which it is specifically furnished. titel COLOR MIN. QTY. MAX. QTY. Red 1 1 Black 1 1 Black 1 1 Black 1 1 Green 1 6 Red 1 6 Green/Gray 1 6 Red/Gray 1 6 22 mm Thermoplastic Enclosure Mushroom Push-Turn Operator P2AML4 drawn by: Philipp Ernstberger checked by: Laszlo Gyorgypal released by: Laszlo Gyorgypal 11/5/2007 drawing no.: rev.: 11/5/2007 1PB-P2AML4 11/5/2007 scale: - - sheet: 1 of: 1