CAMBION Wearnes Cambion LTD â Castleton, Hope Valley, Derbyshire, S33 8WR, England Telephone: +44(0)1433 621555 Fax: +44(0)1433 621290 Web: www.cambion.com Email: [email protected] Technical Data Sheet 435-3803, Manual Bench Press How to order code 435-3803-01-00-00 Fig. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 BENCH PRESS SPARES Description Part Number Base, Cast Iron 430-3806-01-00-10 Handle Assembly 430-3807-01-00-00 Anvil Plate 430-3812-01-07-00 Board Support Rod 430-3813-01-07-00 Cam Shaft 430-3814-01-00-00 Brass Locking Pad 430-3815-03-00-00 Domed Hex Nut (was thumb nut) (5/16 - 18) 931-3684-01-29-00 Thumb Screw (10 - 24) 330-3817-01-12-00 Spring Pin 315-3811-01-00-00 Compression Spring 345-3818-01-00-00 Punch See product pages for part number Anvil See product pages for part number Thumb Nut (10 - 24) 310-3829-01-12-00 Set Screw 330-1914-01-12-00 Machined Socket Head Screw (8 - 32) 330-0176-07-12-00 Set Screw (8 - 32) 330-1914-01-12-00 Name Plate 610-5579-01-00-00 Drive Screw (No. 4) 330-3820-01-00-00 Retaining Ring 345-3821-01-00-00 Tool Kit 390-0081-01-00-00 Copyright Cambionâ Tuesday, 04 December 2001 Page 1 of 2 CAMBION â Technical Data Sheet Stage 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Wearnes Cambion LTD Castleton, Hope Valley, Derbyshire, S33 8WR, England Telephone: +44(0)1433 621555 Fax: +44(0)1433 621290 Web: www.cambion.com Email: [email protected] Tool installation instructions Instruction Loosen screws (15) in anvil plate (3) Install anvil (12) in anvil plate (3) Remove domed hex nuts (were thumb nuts) (7), cam shaft (5) and handle assembly (2) Install retaining ring (19) on punch (11) Install punch, inserting through compression spring (10) Reassemble handle assembly (2), cam shaft (5) and domed hex nut (were thumb nuts) (7) Bring handle forward so that punch (11) touches anvil (12) Line up punch and anvil by moving anvil plate (3) Lock anvil plate in place by tightening screws (15) Adjust anvil height by screwing into anvil plate, so that the clearance between punch and anvil, with handle all the way forward, is slightly less than the thickness of the board to be swaged Lock anvil in place by tightening set screw (14) Properly locate board support rods (4), (if needed) to fit board to be swaged Adjust thumb screws (8) so that the board will be level, and lock in place with thumb nuts (13) Copyright Cambionâ Tuesday, 04 December 2001 Page 2 of 2