FR301GP THRU FR307GP Shanghai Lunsure Electronic Technology Co.,Ltd Tel:0086-21-37185008 Fax:0086-21-57152769 Features • • • • • • 3 Amp Fast Recovery Rectifier 50 to 1000 Volts Low Cost Low Leakage Low Forward Voltage Drop High Current Capability Fast Switching Speed For High Efficiency Glass Passivated Junction Maximum Ratings • • DO-201AD Operating Temperature: -55°C to +150°C Storage Temperature: -55°C to +150°C Catalog Number FR301GP FR302GP FR303GP FR304GP FR305GP FR306GP FR307GP Device Marking --------------- Maximum Reccurrent Peak Reverse Voltage 50V 100V 200V 400V 600V 800V 1000V Maximum RMS Voltage 35V 70V 40V 280V 420V 560V 700V Maximum DC Blocking Voltage 50V 100V 200V 400V 600V 800V 1000V D A Cathode Mark B D Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward IF(AV) 3A TA = 55°C Current Peak Forward Surge IFSM 150A 8.3ms, half sine Current IFM = 3.0A; Maximum 1.3V Instantaneous VF TA = 25°C Forward Voltage Maximum DC Reverse Current At IR 5µA TA = 25°C Rated DC Blocking 100µA TA = 55°C Voltage Maximum Reverse Recovery Time 150ns IF=0.5A, IR=1.0A, FR301GP-304GP Trr 250ns Irr=0.25A FR305GP 500ns FR306GP-307GP Typical Junction CJ 50pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse Test: Pulse Width 300µsec, Duty Cycle 1% C DIMENSIONS DIM A B C D INCHES MIN ----.048 1.000 www.cnelectr.com MAX .370 .250 .052 --- MM MIN ----1.20 25.40 MAX 9.50 6.40 1.30 --- NOTE FR301GP thru FR307GP Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 3.0 6 4 2.5 2 25°C Amps 2.0 1 .6 1.5 Amps .4 1.0 .2 .5 .1 Single Phase, Half Wave 60Hz Resistive or Inductive Load .06 0 .04 0 50 75 100 125 150 175 °C .02 .01 .4 .6 .8 1.0 1.2 Average Forward Rectified Current - Amperesversus Ambient Temperature - °C 1.4 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF TJ=25°C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 Junction Capacitance - pFversus Reverse Voltage - Volts www.cnelectr.com 400 1000 FR301GP thru FR307GP Figure 4 Peak Forward Surge Current 150 125 100 75 Amps 50 25 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.cnelectr.com