MCC omponents 21201 Itasca Street Chatsworth !"# $ % !"# Features • • • • • • UF4014GP THRU UF4016GP 1 Amp Glass Passivated Ultra Fast Recovery Rectifier 1400 to 1600 Volts Low Cost Low Leakage Low Forward Voltage Drop High Current Capability Fast Switching Speed For High Efficiency Glass Passivated Junction Maximum Ratings • • DO-41 Operating Junction Temperature: -50°C to +150°C Storage Temperature: -50°C to +150°C MST Catalog Number Device Marking UF4014GP UF4016GP ----- Maximum Reccurrent Peak Reverse Voltage 1400V 1600V Maximum RMS Voltage 980V 1120V Maximum DC Blocking Voltage 1400V 1400V D A Cathode Mark B D Electrical Characteristics @ 25°C Unless Otherwise Specified Average Forward Current Peak Forward Surge Current Maximum Instantaneous Forward Voltage Maximum DC Reverse Current At Rated DC Blocking Voltage Maximum Reverse Recovery Time IF(AV) 1.0 A IFSM 30A 8.3ms, half sine VF 2.5V IFM = 1.0A; TA = 25°C TA = 55°C C DIMENSIONS IR 10µA 100µA TA = 25°C TA = 100°C Trr 100ns IF=0.5A, IR=1.0A, Irr=0.25A DIM A B C D INCHES MIN .166 .080 .028 1.000 Typical Junction CJ 15pF Measured at Capacitance 1.0MHz, VR=4.0V *Pulse Test: Pulse Width 300µsec, Duty Cycle 1% www.mccsemi.com MAX .205 .107 .034 --- MM MIN 4.10 2.00 .70 25.40 MAX 5.20 2.70 .90 --- NOTE MCC UF4014GP thru UF4016GP Figure 1 Typical Forward Characteristics 20 Figure 2 Forward Derating Curve 10 1.2 6 4 1.0 2 25°C Amps .8 1 .6 .6 Amps .4 .4 .2 .2 .1 Single Phase, Half Wave 60Hz Resistive or Inductive Load .06 0 .04 0 50 75 100 125 150 175 °C .02 .01 1.7 1.9 2.1 2.3 2.5 Average Forward Rectified Current - Amperesversus Ambient Temperature - °C 2.7 Volts Instantaneous Forward Current - Amperesversus Instantaneous Forward Voltage - Volts Figure 3 Junction Capacitance 100 60 40 20 pF TJ=25°C 10 6 4 2 1 .1 .2 .4 1 Volts 2 4 10 20 40 100 200 400 Junction Capacitance - pFversus Reverse Voltage - Volts www.mccsemi.com 1000 MCC UF4014GP thru UF4016GP Figure 4 Peak Forward Surge Current 60 50 40 30 Amps 20 10 0 1 2 4 6 8 10 20 40 60 80 100 Cycles Peak Forward Surge Current - Amperesversus Number Of Cycles At 60Hz - Cycles Figure 5 Reverse Recovery Time Characteristic And Test Circuit Diagram 50Ω 10Ω trr +0.5A 0 Pulse Generator Note 2 25Vdc 1Ω Notes: 1. Rise Time = 7ns max. Input impedance = 1 megohm, 22pF 2. Rise Time = 10ns max. Source impedance = 50 ohms 3. Resistors are non-inductive Oscilloscope Note 1 -0.25 -1.0 1cm Set Time Base for 20/100ns/cm www.mccsemi.com