CONNOR-WINFIELD ABOV5S3E

THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX
(630) 851-5040.
PHONE (630) 851-4722.
WWW.CONWIN.COM
PRODUCT
D ATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
STRATUM 3E HCMOS VCOCXO
ABSOLUTE MAXIMUM RATINGS
PARAMETER
Storage Temperature
Supply Voltage
MINIMUM
-55
NOMINAL
-
MAXIMUM
125
UNITS
°C
(Vcc)
-0.5
-0.5
-
7
Vdc
-
Vcc+0.5
Vdc
MINIMUM
-0.2
-0.5
-0.5
-1
-30
-40
NOMINAL
10 or 12.8
MAXIMUM
0.2
10
0.5
0.5
1
30
200
75
UNITS
MHz
ppm
ppb
ppb
ppb
ppb/day
ppb
RMS
ppb
°C
4.75
-
5.00
-
-100
-
5
-
5.25
3.5
1.8
500
100
5
1
Vdc
W
W
mS
ppb
ppb/G
nS
nS
MINIMUM
NOMINAL
MAXIMUM
UNITS
NOTE
0.5
±0.45
50K
2.5
-
4.5
±1.0
-
Vdc
ppm
Ohm
10
OPERATING SPECIFICATIONS
Supply Voltage
Power Consumption: Turn On
Power Consumption: Steady-State
Start-Up Time
Warm Up
2G Tip-over
TDEV at 300 seconds
TDEV at 40 seconds
(Fo)
(Vcc)
ABOV5S3E
5.00E-11
-
NOTE
1
2
3
4
5
6
6
7
8
9
9
TABLE 3.0
PARAMETER
Vc
HCMOS OUTPUT CHARACTERISTICS
PARAMETER
LOAD
Voltage
(High)
(Low)
Duty Cycle at 50% of Vcc
Rise / Fall Time 10% to 90%
Spurious Output
SSB Phase Noise at 1Hz offset
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
NOTE
TABLE 2.0
INPUT CHARACTERISTICS
Control Voltage (Pin 1)
Deviation @ 25°C referenced to Fo
Input Impedance (Pin 1)
MODEL ABOV5S3E
FREQUENCY 10.000MHz
0746
DATE CODE
CAL. FREQ. 10.000000
TABLE 1.0
UNITS
Input Voltage
PARAMETER
Center Frequency
Frequency Calibration (Vc= 2.5 Vdc)
Frequency Stability
Voltage Stability (+/-1%) ref. 5.0 Vdc
Load Stability (+/-20%) ref. 15 pF
Aging: Daily
Aging: First Year
Aging: Short Term (1Sec.)
Aging: Long Term (20 Years)
Operating Temperature Range
CONNOR
WINFIELD
(Voh)
(Vol)
TABLE 4.0
MINIMUM
12
Vcc-0.2V
45
-
NOMINAL
15
50
-
-
SSB Phase Noise at 10KHz offset
-
MAXIMUM
18
0.2
55
5
-80
-90
-115
-130
-140
UNITS
pF
Vdc
Vdc
%
nS
dBc
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-
-150
dBc/Hz
NOTE
11
DESCRIPTION
The Connor-Winfield
ABOV5S3E is a 5V Voltage
Controlled Oven Controlled
Crystal Oscillator (VCOCXO)
with an HCMOS output. The
ABOV5S3E is designed for
Stratum 3E applications
requiring low jitter and tight
frequency stability.
FEATURES
DESIGNED TO MEET STRATUM 3E
REQUIREMENTS
VCOCXO
FREQUENCY STABILITY: 10ppb
ABSOLUTE
TEMPERATURE RANGE: 0
to 70C
5.0V OPERATION
HCMOS OUTPUT
RoHS 5/6 COMPLIANT
ORDERING INFORMATION
RE-STABILIZATION TIME
Off Time
< 1 Hour
< 6 Hours
< 24 Hours
1 to 16 Days
> 16 Days
TABLE 5 .0
NOTE
12
12
12
12
12
Re-stabilization Time
< 2 Hours
< 12 Hours
< 48 Hours
48 Hours + ¼ Off Time
< 6 Days
ABOV5S3E
OCXO
SERIES
- 010.0M
CENTER
FREQUENCY
Specifications subject to change without notice.
DATA SHEET #:
Cx057
PAGE 1
OF
2
REV: 01
DATE:
11/02/07
aCopyright 2007 Connor-Winfield all rights reserved.
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX
(630) 851-5040.
PHONE (630) 851-4722.
WWW.CONWIN.COM
PRODUCT
D ATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
PACKAGE CHARACTERISTICS
Package
Solder Process
Pin Connections
TABLE 6.0
Metal package: solder sealed, grounded case, solder tinned pins.
RoHS 5/6 compliant, see solder profile below.
ENVIRONMNETAL CHARACTERISTICS
TABLE 7.0
100G’s, 6mS, halfsine per MIL-STD-202F, Method 213B, Test Condition C
0.06” D.A. or 10G peak 10 to 500 Hz, per MIL-STD-202F, Method 204D, Test
condition A
Shock
Vibration
Notes:
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
12)
CONTROL VOLTAGE
Labels will include the calibration frequency at the time of ship.
Initial calibration referenced to Fo at time of shipment @ 25C, Vc=2.5Vdc.
Frequency vs. temperature stability, absolute change over 0 to 70C.
After ten days of continuous operation.
Allen Variance: 1 second, 100 average.
Vcc = 5.0Vdc.
From Vcc=90% of final value. No more than 16 transitions at start-up before oscillator
has started.
Measured @ 0C, within 5 minutes, referenced one hour after turn-on.
After re-stabilization time.
Positive slope.
HCMOS load.
For a given off time, the time required to meet daily aging, short-term stability and TDEV
requirements.
Labeling Diagram
MODEL
ABOV5S3E
FREQUENCY 10.000MHz
DATE CODE
0746
CAL. FREQ.
10.000000
Package Outline
.500
12.700mm
Test Circuit
Solder Profile
Temperature
REF.
SUPPLY
225°C
+4.5Vdc
183°C
150°C
Ramp-Up Rate
3°C/second max.
from 150°C to 225°C.
225°C
tp
Ramp-Down Rate
6°C/second max.
100°C
25°C
0
Time
60-120s
Max.
10-30s
60-150s Max.
360 Sec. Max.
Specifications subject to change without notice.
DATA SHEET #:
Cx057
PAGE 2
OF
2
REV:
01
DATE:
11/02/07
aCopyright 2007 Connor-Winfield all rights reserved.