THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 12.00V SINEWAVE OCXO ABSOLUTE M AXIMUM RATING S PARAMETER Storage Temperature Supply Voltage MINIMUM -40 NOMINAL - MAXIMUM 85 UNITS °C (Vcc) -0.5 - 12.6 Vdc NOTE TABLE 2.0 PARAMETER MINIMUM Center Frequency Frequency Calibration Frequency Stability Aging: Daily Aging: First Year Aging: Long Term (20 Years) Operating Temperature Range (Fo) Supply Voltage Voltage Stability (+/-1%) Load Stability (+/-10%) Allan Variance (1 second) Period Jitter Power Consumption: Turn On Power Consumption: Steady-State Start-Up Time Warm Up 2G Tip-over (Vcc) NOMINAL MAXIMUM UNITS 0.2 20 1 50 500 70 MHz ppm ppb ppb/day ppb ppb °C 10 -0.2 -20 -40 - 11.40 -2 -0.5 - 12.00 2.00E-11 - -100 - 5 PARAMETER LOAD Output Power Spurious Output SSB Phase Noise at 1Hz offset SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset MINIMUM 45 5.0 NOMINAL 50 - - SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset 12.60 2 0.5 3 3.50 2.00 500 100 - ps rms W W mS ppb ppb/G -85 -115 -140 -150 MAXIMUM 55 12 -80 - UNITS ohms dBm dBc dBc/Hz dBc/Hz dBc/Hz dBc/Hz - -155 - dBc/Hz - -155 - dBc/Hz 1 2 3 4 4 5 6 TABLE 3.0 RESTABILIZATION TIME Off Time < 1 Hour < 6 Hours < 24 Hours 1 to 16 Days > 16 Days NOTE DESCRIPTION The Connor Winfield OFC12CJ4BA is a 12.00V Oven Controlled Crystal Oscillator (OCXO) with a Sinewave output. The OFC12CJ4BA is designed for applications requiring tight frequency stability and low noise. FEATURES OCXO 12.00V OPERATION DESIGNED FOR TIGHT FREQUENCY STABILITY APPLICATIONS FREQUENCY STABILITY: 20ppb ABSOLUTE TEMPERATURE RANGE: -40 to 70C SINEWAVE OUTPUT TABLE 4 .0 NOTE 7 7 7 7 7 Restabilization Time < 2 Hours < 12 Hours < 48 Hours 48 Hours + ¼ Off Time < 6 Days OFC12CJ4BA NOTE Vdc ppb ppb SINEWAVE OUTPUT CHARACTERISTICS PACKAG E CHARACTERISTICS MODEL OFC12CJ4BA FREQUENCY 10.000MHz 0646 DATE CODE CAL. FREQ. 10.000000 TABLE 1.0 UNITS OPERATING SPECIFIC ATIONS Package Soldering Process CONNOR WINFIELD TABLE 5.0 Metal package: solder sealed, grounded case, solder tinned pins. See solder profile on page 2. RoHS 5/6 COMPLIANT ORDERING INFORMATION OFC12CJ4BA OCXO SERIES - 10.00MHz CENTER FREQUENCY ENVIRONMNETAL CHARACTERISTICS TABLE 6.0 100G’s, 6mS, halfsine per MIL-STD-202F, Method 213B, Test Condition C Shock Specifications subject to change without notice. DATA SHEET #: Cx109 PAGE 1 OF 2 REV: 00 DATE: 11/20/06 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS Notes: 1) 2) 3) 4) 5) Initial calibration @ 25°C, at time of shipment. Frequency vs. temperature stability referenced to 25°C. After ten days of continuous operation. Vcc = 12.00Vdc. From Vcc=90% of final value. No m ore than 16 transitions at start-up before oscillator has started. 6) Measured @ 0°C, within 5 minutes, refer enced one hour after turn-on. 7) For a given off time, the time r equired to meet daily aging, short-term stability requirements. Package Layout Labeling Diagram .500 12.700mm MODEL OFC12CJ4BA FREQUENCY 10.000MHz DATE CODE 0646 CAL. FREQ. 10.000000 Pin Connections TABLE 7.0 Pin 1 2 3 4 5 Function N/C N/C Supply Voltage (Vcc) Output Circuit and Case Ground Solder Profile Test Diagram Temperature 225°C 225°C tp Ramp-Down Rate 6°C/second max. 183°C 150°C Vcc Output 12.00Vdc Ramp-Up Rate 3°C/second max. from 150°C to 225°C. N/C 100°C N/C Ground 25°C 50 Ohm Scope Input 0 Time 60-120s Max. 10-30s 60-150s Max. 360 Sec. Max. Specifications subject to change without notice. DATA SHEET #: Cx109 PAGE 2 OF 2 REV: 00 DATE: 11/20/06 aCopyright 2001 Connor-Winfield all rights reserved.