THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS 14 PIN DIP 5.0V STRATUM 3 HCMOS OCXO CW 0107 DGOF5S3 33.333333M ABSOLUTE MAXIMUM RATINGS PARAMETER Storage Temperature Supply Voltage TABLE 1.0 UNITS MINIMUM -40 NOMINAL - MAXIMUM 85 UNITS °C (Vcc) -0.5 - 7.0 Vdc NOMINAL - MAXIMUM 38.88 1.0 UNITS MHz NOTE (Fo) MINIMUM 2.50 1, 4 2 3 4 OPERATING SPECIFICATIONS PARAMETER Center Frequency NOTE DGOF5S3 TABLE 2.0 Frequency Calibration Frequency vs. change in Temperature Frequency vs. change in Supply Voltage Aging (Daily) Aging (1st Year) Total Frequency Tolerance Operating Temperature Range -1.0 -0.25 -0.05 -15 -0.7 -2.5 0 - 0.25 0.05 15 0.7 2.5 70 ppm ppm ppm ppb/day ppm ppm °C Vdc Supply Voltage (Vcc) 4.75 5.00 5.25 Supply Current (Icc) - - 300 mA Jitter (BW=10Hz to 20MHz) - - 3 ps rms Allan Variance (1 second) SSB Phase Noise at 10Hz offset SSB Phase Noise at 10KHz offset Start Up Time: Oscillator Warm Up Time TDEV @ 1.0 Sec. TDEV @ 4.0 Sec. - 5.00E-10 -90 -130 - 10 5 1 2 dBc/Hz dBc/Hz mS Minutes nS nS DESCRIPTION The Connor-Winfield DGOF5S3 is a hermetically sealed 14 Pin DIP, 5.0V Oven Controlled Crystal Oscillator (OCXO) HCMOS/TTL Compatible. The DGOF5S3 is designed for a higher stability Stratum 3 application requiring low jitter and tight stability. 5 6 FEATURES 5.0V OPERATION HCMOS OUTPUT CHARACTERISTICS TABLE 3.0 PARAMETER LOAD Voltage (High) (Low) (Voh) (Vol) MINIMUM 4.5 - Current (Ioh) -4 (Ioh) 45 - (High) (Low) Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% PACKAGE CHARACTERISTICS Package NOMINAL - MAXIMUM 15 0.4 UNITS pf Vdc Vdc - mA 50 - 4 55 6 mA % nS LOW JITTER <3pS RMS NOTE TEMPERATURE STABILITY ±0.25ppm FREQUENCY TOLERANCE OF ±2.5ppm OVER TEN YEARS TABLE 4.0 14 pin DIP, hermetically sealed, grounded case, welded pack age ORDERING INFORMATION Notes: 1) 2) 3) 4) 5) Initial calibration @ 25°C. Overall frequency stability, 0 to 70°C. Frequency stability per 5% change in supply voltage. At the time of shipment after 48 hours of operation. Inclusive of calibration, operating temperature range, supply voltage change, load change, shock and vibration, 10 years aging. 6) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference frequency, measured after 30 minutes of continuous operation a t a stable 25°C DGOF5S3 OCXO SERIES - 33.333333MHz CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Cx030 PAGE 1 OF 2 REV: 00 DATE: 7/9/02 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS ENVIRONMENTAL CHARACTERISTICS Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1minute transition. Gross Leak Test: Per MIL-STD-202, Method 112, Condition D. No bubbles in flourinert (FC-43) at 125°C ±5°C for 20 seconds. SOLDERING Pin Solderability: Per MIL-STD-883, Method 200. 38 hour steam age prior to 254°C ±5°C Solder pot dip, 95% Coverage. Resistance to Solder Heat: Per MIL-STD-202, Method 210, Condition C. Wave: Tops ide board-mount product, 260°C ±5°C for 20 Seconds. MECHANICAL CHARACTERISTICS Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15m inute cycles 12 times each perpendi cular axis. Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, halfsine, 3 shocks per direction. Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C. Specifications subject to change without notice. DATA SHEET #: Cx030 PAGE 2 OF 2 REV: 00 DATE: 7/9/02 aCopyright 2001 Connor-Winfield all rights reserved.