EURO QUARTZ XO91 Series Oscillators Miniature 7.0 x 5.0 x 1.4mm hermetically-sealed package Frequency Range 500kHz to 125MHz Tristate (Enable/Disable) function as standard Supply voltage range 1.8, 2.5, 3.3 or 5.0 Volts DESCRIPTION 7 x 5mm SMD HCMOS Page 1 of 2 OUTLINE & DIMENSIONS XO91miniature oscillators consist of a TTL/CMOS-compatible hybrid circuit together with a miniature quartz crystal packaged in a lowprofile, industry-standard ceramic package. The high quality design and materials employed provide a highly reliable clock oscillator in a miniature package while mass production methods ensure that the XO91 provides a cost-effective oscillator solution. SPECIFICATION Frequency Range: Supply Voltage: Output Logic: Frequency Stability* Temperature Range 0° to +50°C: -20° to +70°C: -40 to +85°C: -55° to +105°C: Rise/Fall Time: Output Voltage: HIGH ‘1’: LOW ‘0’: Output Load CMOS: TTL: Duty Cycle: Supply Current: Operating Temperature 500kHz to 125.0MHz 1.8, 2.5, 3.3 or 5.0 Volts ±10% HCMOS/LSTTL Stability from ±10ppm from ±15ppm from ±25ppm from ±100ppm see table 90%Vdd minimum 10%Vdd maximum 15pF (50pF available) 10 LSTTL loads 50%±5% typical See table Storage Temperature: Startup Time 500kHz to 32MHz: 32MHz+ to 125MHz: 0~50°C (Light Commercial) 0~70°C (Commercial) -40~+85 (Industrial) -55~+105°C (Military) -55~+105°C 5ms max. 10ms max. (to reach 90% amplitude at 25±2°C) ±5ppm max. In first year <1ps typical 100ms max. 100ns max. SOLDER TEMPERATURE PROFILE Ageing: Phase Jitter RMS: Enable Time: Disable Time: Tristate Function (Pad 1): Output (Pad 3) is active if Pad 1 is not connected or a voltage to Pad 1 is 'HIGH'. Output is high impedance when 'LOW' or GROUND is applied to Pad 1. * Frequency stability is inclusive of calibration tolerance at 25°C, frequency change due to shock & vibration, ±10 supply voltage variation and stability over temperature range. Note: Parameters are measured at ambient temperature of 25°C, supply voltage as stated and a load of 15pF CURRENT CONSUMPTION & RISE/FALL TIME Frequency Range 500kHz to 32MHz 32MHz+ to 50MHz 40MHz+ to 125MHz Supply Voltage (±10%) +1.8V 8mA 10mA 25mA +2.5V +3.3V +5.0V 10mA 14mA 30mA 15mA 25mA 16.5mA 35mA 35mA 40mA Rise/Fall Time 4ns max. 3ns max. 2ns max. EUROQUARTZ LIMITED Blacknell Lane CREWKERNE Somerset UK TA18 7HE Tel: +44 (0)1460 230000 Fax: +44 (0)1460 230001 Email: [email protected] www.euroquartz.co.uk EURO QUARTZ XO91 Series Oscillators 7 x 5mm SMD HCMOS Page 2 of 2 ENVIRONMENTAL PERFORMANCE SPECIFICATION RoHS Status: Storage Temperature Range: Humidity: Hermetic Seal: Solderability: Reflow: Vibration: Shock: Compliant -50° to +100°C 85% RH, 85°C for 48 hours Leak rate 2x10-8 ATM -cm3/s max. MIL-STD-202F Method 208E 260°C for 10 sec (see diagram) MIL-STD-202F Method 204, 35g, 50 to 2000Hz MIL-STD-202F Method 213B, test Condition E, 1000g ½ sinewave PART NUMBERING Example: 16.000MHz XO91050UCTA Frequency Series Designation XO91 Stability* 100 = ±100ppm 50 = ±50ppm 25 = ±25ppm Output Universal Operating Temp. Range C = 0+70°C D = -20~+70°C I = -40~+85°C M = -55~+105°C Tristate Function Supply Voltage Blank = 5.0 Volts A = 3.3 Volts B = 2.5 Volts C = 1.8 Volts * For other stability requirements enter figure required. EUROQUARTZ LIMITED Blacknell Lane CREWKERNE Somerset UK TA18 7HE Tel: +44 (0)1460 230000 Fax: +44 (0)1460 230001 Email: [email protected] www.euroquartz.co.uk