CS8818 General Purpose USB2.0-to-ATAPI Bridge Controller with Embedded PHY FEATURES • Fully compatible with USB specification 2.0 - Support full-speed (12M bits/sec) or high-speed (480M bits/sec) devices with multiple configurations and multiple interfaces - Support all USB standard commands, including suspend and resume detection logic - Support USB 2.0 TEST mode features • Supports 5 endpoints - All endpoints share one on-chip 4K bytes SRAM buffer and the size of each endpoint is configurable - Default control endpoints (EP0) with up to 64-byte buffer on either TX or RX direction - An interrupt OUT endpoint (EP1) and an interrupt IN endpoint (EP2) - A bulk OUT endpoint (EP3) and a bulk IN endpoint (EP4): up to 512 bytes data payload for full/high speed bulk endpoint - Unused endpoint can be disabled • Embedded USB 2.0 transceiver - Integrated bit stuffing/unstuffing and stuff error detection - NRZI (Non-Return-to-Zero Inverted) encoding/decoding • USB Mass Storage Class Bulk-Only Specification Compliant (Version 1.0) • Support Bus Powered and Self Powered modes • Support multiple LUNs • Automatic detection of Master or Slave ATAPI devices • Support true ATAPI compatible interface - Complies with ATAPI-7 Specification (PIO mode 0,3,4, Multiword DMA mode 0~2, UDMA mode 0~6) - 8-bit/16-bit Standard PIO mode interface - 16-bit Multiword DMA mode and UDMA mode interface (Ultra 133) • ATAPI bus can be shared with other devices • Embedded 8-bit microprocessor with on-chip 8K x 14 program ROM and optional external 16K x 14 program ROM/Flash memory • Flexible 32-bit I/O interfaces providing maximum versatility with ROM mask changeable firmware Myson Century, Inc. Taiwan: No. 2, Industry East Rd. III, Science-Based Industrial Park, Hsin-Chu, Taiwan Tel: 886-3-5784866 Fax: 886-3-5784349 • Firmware to support ATAPI CD-ROM/CD-RW/DVD-ROM/DVD-RW is provided • 12MHz external clock input to provide better EMI • Low power with operation voltage 3.3V with 5V tolerance I/O pads • Available in 64-pin LQFP (10mm x 10mm) production package and 128-pin QFP (14mm x 20mm) development package GENERAL DESCRIPTION The CS8818 is a single chip USB (Universal Serial Bus) 2.0 Mass storage class peripheral controller intended for use with standard ATAPI devices. The device consists of a USB 2.0 PHY and SIE, FIFO buffers, embedded microprocessor with expanded external program ROM/Flash memory, and ATAPI compatible interface. The CS8818 uses 12MHz crystal to reduce the EMI issue. With flexible 32-bit I/O interface, the CS8818 can be programmed to fit different situations in the USB 2.0 high speed mass storage class applications such as CD-ROM, CD-RW, DVD-R and DVD-RW, etc. USA: 4020 Moorpark Avenue, Suite 115 San Jose, CA, 95117 Tel: 408-243-8388 Fax: 408-243-3188 [email protected] www.myson.com.tw Rev. 1.0 April 2003 page 1 of 41 CS8818 BLOCK DIAGRAM HS/ FS-TX DP USB UTMI 2.0 Logic XCVR USB Control Manager SIE DIO Microcontroller CGM CLK Clock Multiplier To ATAPI UDMA USB Packet Manager REF 32-bit I/O Interface Buffer Manager HS/ FS-RX DM Embedded Program ROM 8KB SRAM External Crystal Input page 2 of 41