Surface Mount LED J Series for low current or superbright use, 0358 Series Reverse Mount with Inner Lens The 0358 series is designed to mount to pads on the lower side of a pcb with the LED viewed through a hole. This has the benefit maintaining all parts of the LED below the surface of the PCB, making it especially suitable for use with membrane overlays and applications where a smooth front surface is desired. It is the same as the 0348 series except that it incorporates a lens to provide a different view effect. 3.2 1.6 1.6 AAA - + 1.1 0.3 AA AA AAAA 1.8 1.6 2.0 1.6 AAA AAAA AAA 1.6 Suggested pad dimensions for reflow soldering Cathode mark GENERAL INFORMATION Operating Temperature Range Storage Temperature Range Reflow Soldering Temperature -40 °C to +85 °C -40 °C to +90 °C 260 °C for 5 sec max APPLICATION INFORMATION (ALL RATINGS AT 25 °C AMBIENT) Peak Part No. Emitted Color λ Absolute Maximum Ratings ∆λ Pd If (mA) Ir E/O Characteristics Iv (mcd) @If=20mA Vr Vf (V) @ If=20mA 2Θ1/2 (nM) (nM) (mW) dc 1/10 duty @ 1 khz @Vr=5V (µA) (V) 2mA Min Typ Min Typ (Deg) JRC0358 Red 632 20 60 25 160 10 5 3 18 44 2.0 2.4 130 JGC0358 Green 575 20 60 25 160 10 5 1 12 18 2.0 2.4 130 JYC0358 Yellow 591 15 60 25 160 10 5 3 18 45 2.0 2.4 130 JOC0358 Orange 621 18 60 25 160 10 5 3 18 45 2.0 2.4 130 JYOC0358 YelOrng 611 17 60 25 160 10 5 3 18 45 2.0 2.4 130 Specifications subject to change without notice. Dimensions are in mm±0.3 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph:714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0508 J–13 013S-J0358