Surface Mount LED J Series for low current or superbright use, 0125 Series Low Profile Right Angle Lens The 0125 series lamps are miniature chip type designed for two-way surface mounting. Mounted normally, these lamps can be used as circuit board status indicators or as backlight for switches or key pads. Mounted at right angles these lamps are miniature through the panel indicators. These lamps are in EIA481 tape and reel packaging with approximately 2000 pcs per reel. 2.1±.2 0.6 - 1.7 + AA AA AA AA 1.5 0.5 AA AA Suggested pad dimensions for reflow soldering 0.3 0.3 0.8 0.8 0.5 1.0 cathode mark GENERAL INFORMATION Operating Temperature Range Storage Temperature Range Reflow Soldering Temperature -40 °C to +85 °C -40 °C to +90 °C 260 °C for 5 sec max APPLICATION INFORMATION (ALL RATINGS AT 25 °C AMBIENT) Peak Part No. Emitted Color λ Absolute Maximum Ratings ∆λ Pd If (mA) Ir E/O Characteristics Iv (mcd) @If=20mA Vr Vf (V) @ If=20mA 2Θ1/2 (nM) (nM) (mW) dc 1/10 duty @ 1 khz @Vr=5V (µA) (V) 2mA Min Typ Min Typ (Deg) JRC0125 Red 632 20 60 25 160 10 5 3 20 48 2.0 2.4 130 JGC0125 Green 575 20 60 25 160 10 5 1 13 20 2.0 2.4 130 JYC0125 Yellow 591 15 60 25 160 10 5 3 20 49 2.0 2.4 130 JOC0125 Orange 621 18 60 25 160 10 5 3 20 49 2.0 2.4 130 JYOC0125 YelOrng 611 17 60 25 160 10 5 3 20 49 2.0 2.4 130 Specifications subject to change without notice. Dimensions are in mm±0.3 unless stated otherwise. IDEA, Inc., 1351 Titan Way, Brea, CA 92821 Ph:714-525-3302, 800-LED-IDEA; Fax: 714-525-3304 0508 J–3 013S-J0125