Pb Lead-Free Parts LFHRF3363-PF FLASH ROUND TYPE LED LAMPS Page 1/2 SERIES Package Dimension Features • Built-in IC chip flashes lamps on and off to attract attention • Pulse rate 2.4Hz • T-1 size • 1 inch leads • Large full flood radiating area • IC compatible 5.0 5.9 7.6 8.6 1.5 MAX Description □0.5 TYP The LFHRF3363-PF series is a solid state lamp with a red diffused plastic lens The built-in IC flashes the lamp on/off and can be driven directly by standard TTL and CMOS circuit eliminating the need for external switching circuitry 25.0MIN 1.0MIN 2.54TYP Note:1.All dimension are in millimeter tolerance is ±0.25mm unless otherwise noted 2.Specifications are subject to change without notice •Part Selection And Application Information (Ratings At 25℃ Ambient) Dominant Spectral wave halfwidth length △λnm λDnm COLOR PART NO MATERIAL Emitted LFHRF3363-PF AlGaInP Red Lens 630 Water Clear 20 Pulse rate(Hz) volt=5v Luminous intensity volt=5v(mcd) Operating voltage Min. Max. Min. Typ. Min. Max. 2.0 3.0 120 220 3.0 12 •Absolute Maximum Rating (Ta=25℃) PARAMETER RED GREEN YELLOW ORANGE UNIT REMARK HRF Peak Current (1/4) Duty cycle 60 mA Operating Voltage 15 V Reverse Voltage 0.4 V Operating Temperature Storage Temperature DOC NO:QW0905-LFHRF3363-PF 0℃ TO +85℃ -20℃ TO +85℃ REV. : A DATE:01 - Jun. - 2006 LIGITEK ELECTRONICS CO.,LTD. Property of Ligitek Only LFHRF3363-PF FLASH ROUND TYPE LED LAMPS Page 2/2 Soldering Condition(Pb-Free) 1.Iron: Soldering Iron:30W Max Temperature 350 ° C Max Soldering Time:3 Seconds Max(One Time) Distance:2mm Min(From solder joint to body) 2.Wave Soldering Profile Dip Soldering Preheat: 120° C Max Preheat time: 60seconds Max Ramp-up 2°C/sec(max) Ramp-Down:-5° C/sec(max) Solder Bath:260° C Max Dipping Time:3 seconds Max Distance:2mm Min(From solder joint to body) Temp(° C) 260° C3sec Max 260° 5° /sec max 120° 25° 0° 0 2° /sec max Preheat 60 Seconds Max 50 100 150 Time(sec)