MWP-610P 304W Triple Output for Video Game Features : 230VAC input only Built-in passive PFC, PF>0.7 Economical video game power Power ON-OFF switch Protections: Short circuit / Overload / Over voltage / Over temperature Forced air cooling by built-in DC fan 100% full load burn-in test 2 years warranty SPECIFICATION MODEL NO. MWP-610P CHANNEL CH1 CH2 DC VOLTAGE 5V 12V 24V MINIMUM CURRENT 1.5A 1A 0.5A 8A 4.5A 12A 5A 150mVp-p 200mVp-p RATED CURRENT (CONTINUOUS) 8A PEAK CURRENT (10 min.) 8A CH3 RATED POWER (CONTINUOUS) 244W OUTPUT 304W PEAK POWER (10 min.) RIPPLE & NOISE (max.) Note.2 80mVp-p VOLTAGE TOLERANCE 5.0% 5.0% 5.0% LINE REGULATION 1.0% 1.0% 1.0% 5.0% 5.0% 5.0% LOAD REGULATION Note.3 HOLD UP TIME 12ms min. at full load AC RECEPTACLE RATED (max.) 1A / 230VAC 200 ~ 264VAC VOLTAGE RANGE INPUT PROTECTION FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) EFFICIENCY (Typ.) PF>0.7 / 230VAC 76% AC CURRENT INRUSH CURRENT (max.) 4.5A / 230VAC 80A / 230VAC LEAKAGE CURRENT(max.) 3.5mA / 240VAC OVERLOAD 105 ~ 200% rated output power Protection type : Shut down o/p voltage, re-power on to recover OVER VOLTAGE 105 ~ 140% rated output voltage Protection type : Shut down o/p voltage, re-power on to recover OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION (Note 4) OTHERS NOTE Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -10 ~ +50 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05% / ( 0 ~ 50 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes Design refer to EN60950-1 I/P-O/P, I/P-FG:1.5KVAC I/P-O/P, I/P-FG:50M Ohms / 500VDC / 25 Compliance to EN55022 Class B / 70% RH HARMONIC CURRENT Compliance to EN61000-3-2,-3 EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A CONNECTOR See page 2 COOLING DIMENSION 150*140*86mm (L*W*H) Forced air ventilation by 8cm DC fan 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Load regulation is measured from 20% to 100% max. Load. 4. The power supply is considered as an independent unit, but the final equipment still need to re-confirm that the whole system complies with the EMC directives. File Name: MWP-610P-SPEC 2010-04-28 MWP-610P 304W Triple Output for Video Game Mechanical Specification Unit: mm 86 80 140 42.55 16 6 52.4 120 138 118.5 150 OUTPUT WIRES 29.5 61.8 69.9 350 50 25 PIN12 PIN9 PIN4 PIN1 Pin No. Assignment :JST ELR-12V or equivalent Pin No. 1 2 3 4 Assignment +12V GND +24V +5V Pin No. 5 6 7 8 Assignment +12V GND +24V +5V Derating Curve Pin No. 9 10 11 12 Assignment +12V GND GND +5V Static Characteristics Ta=25 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -10 0 10 20 30 35 40 50 AMBIENT TEMPERATURE ( ) 60 (HORIZONTAL) 60 50 40 200 210 220 230 240 264 INPUT VOLTAGE (VAC) 60Hz File Name: MWP-610P-SPEC 2010-04-28