Pluggables Datasheet OP SFP Multi Rate Bidirectional Transceivers SFP-MR-35IR1 and SFP-MR-53IR1 Features 100 Mbps-2.7 Gbps data rates OC-48/STM-16 standard compliances IEEE 802.3ah, 1000Base-BX10 compatibility Simplex LC connector 13 dB minimum power budget 15 km minimum reach Single 3.3 V supply 1310 nm or 1550 nm DFB laser Digital Diagnostic SFF-8472 compliance Telcordia GR-468 compliance GR 253/STM G.957 compliance RoHS and China RoHS compliance SFP MSA SFF-8074i compliance 21CFP 1040.10 and 1040.11 compliance TÜV compliance Commercial temperature rating Class 1 Laser Color coded bail latch: Blue or Yellow General Operating Parameter Supply Voltage Total Current Power Supply Noise Rejection Operating Temperature Storage Temperature Data Rate Symbol Vcc Icc Min. 3.135 - Typical 3.3 - Max. 3.465 300 Unit V mA PSR Top Tst DR 100 -5 -40 100 - 70 85 2700 mVp-p ºC ºC Mbps Symbol Min -5 Typical -2.5 Max 0 Unit dBm Transmitter Specifications (Optical) Parameter Optical Power Optical Crosstalk Pop XT - - -45 dB Average Launch Power (Tx: Off ) Poff - - -45 dBm Extinction Ratio ER 8.2 - - dB ps Eye Mask IEEE 802.3 and SONET/SDH compliant Optical Rise Time (20% - 80% values) tr - - 160 Optical Fall Time (20% - 80% values) tf - - 160 ps Mean Wavelength: λ 1280 1310 1335 nm SFP-MR-35IR1 λ 1480 1550 1580 nm - - 1 nm Side Mode Suppression Ration Δλ SMSR 30 - - dB Dispersion Penalty (at 15 km)¹ dp - 0.5 1 dB Relative Intensity Noise RIN - - -120 dB/Hz Transmitter Reflectance Reflectance Tolerance rp -24 - -12 - dB dB SFP-MR-53IR1 Spectral Width (20 dB) 1) Measured at 2.7 Gbps, BER of 10-12, PRBS of 223-1, at eye center [email protected] Pluggables Transmitter Specifications (Electical) Parameter Symbol Min Typical Max Unit Rin 80 100 120 Ω PECL Single Ended Data Input Swing Vin,p-p 250 - 1200 mV TxFault_Fault Vfault 2 - Vcc V Vnormal Vee - Vee+0.5 V Input Differential Impedence TxFault_Normal TxDisable_Disable Vd 2 - Vcc V Ven Vee - Vee+0.8 V Parameter Symbol Min Typical Max Unit Receive Power Low² Rsens,low - -20 -18 dBm Receive Power High² Rsens,high 0 - - dBm Damage Threshold for Receiver TxDisable_Enable Receiver Specifications (Optical) Pin,damage - - 0 dBm SFP-MR-35IR1 λ 1480 - 1600 nm SFP-MR-53IR1 λ 1260 - 1360 nm LOS Assert - -28 - - dBm LOS De-assert - - - -18 dBm LOS Hysteresis - 0.5 - - dB Receiver Reflectance - - - -12 dB Wavelength: 2) Measured at 10-10 BER, 2.7 Gbps, 223-1 PRBS, and 10-12 BER, 1250 Mbps, 27-1 PRBS Receiver Specifications (Electrical) Parameter Symbol Min Typical Max Unit PECL Single Ended Data Output Swing Vout, p-p 185 - 800 mV Data Output Rise Time tr - - 175 ps Data Output Fall Time tf - - 175 ps Timing and Electrical Parameter Symbol Min Typical Max Unit Tx Disable Negate Time t_on - - 1 ms Tx Disable Assert Time t_off - - 10 µs Time to Initialize, Including Reset of Tx Fault t_init - - 300 ms Tx Fault Assert Time t_fault - - 100 µs Tx Disable to Reset t_reset 10 - - µs LOS Assert Time t_loss_on - - 100 µs LOS De-assert Time t_loss_off - - 100 µs Serial ID Clock Rate f_serial_clock - - 100 KHz RX_LOS Voltage (High) RX_LOSH 2 - - V RX_LOS Voltage (Low) RX_LOSL - - 0.8 V LOS Output Voltage-Fault LOS Output Voltage-Normal VLOS fault 2 - Vcc V VLOSnormal Vee - Vee+0.5 V MOD_DEF (0:2)-High Vh 2 - Vcc V MOD_DEF (0:2)-Low Vl Vee - Vee+0.5 V [email protected] Pluggables Digital Diagnostics Parameter Range Accuracy Unit Calibration Bit Value Formula Temperature -5 to 70 ±3 ºC Internal 1/256 C Tc(C)=Tad(16 bit signed twos complement)/256 Voltage 0 to Vcc 0.1 V Internal 100 µV V(Volts)=Vad(16 bit unsigned integer)*0.1 Bias Current 0 to 120 5 mA External 0.002 mA I(mA)=Islope*Iad(16 bit unsigned integer)+Ioffset TX Power -5 to 0 ±2 dB dBm External 0.1µW TX_PWR(µW)=TX_PWRslope*TX_PWRad(16 bit unsigned integer +TX_PWRoffset RX Power -18 to 0 ±2 dB dBm External 0.1µW RX_PWR(µW)=A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Pin Function Notes 1 VeeT TX Ground 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX Ground 15 VccR RX Power 16 VccT TX Power 17 VeeT TX Ground 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX Ground [email protected] Pluggables Outline Drawing Units in mm (inches) Data Rate Wavelength (nm) Bail Latch Color Distance Range (km) SFP-MR-35IR1 SFP Multi Rate Bidirectional Transceiver 100 - 2700 Mbps 1310/1550 Blue 0 -15 SFP-MR-53IR1 SFP Multi Rate Bidirectional Transceiver 100 - 2700 Mbps 1550/1310 Yellow 0 -15 Model Description Ordering Information MRV has more than 50 offices throughout the world. Addresses, phone numbers, and fax numbers are listed at www.mrv.com. Please e-mail us at [email protected] or call us for assistance. MRV (West Coast USA) 20415 Nordhoff St. Chatsworth, CA 91311 800-338-5316 818-773-0900 MRV (East Coast USA) 295 Foster St. Littleton, MA 01460 800-338-5316 978-952-4700 MRV (International) Business Park Moerfelden Waldeckerstrasse 13 64546 Moerfelden-Walldorf Germany Tel. (49) 6105/2070 Fax. (49) 6105/207-100 All statements, technical information and recommendations related to the products herein are based upon information believed to be reliable or accurate. However, the accuracy or completeness thereof is not guaranteed, and no responsibility is assumed for any inaccuracies. Please contact MRV Communications for more information. MRV Communications and the MRV Communications logo are trademarks of MRV Communications, Inc. Other trademarks are the property of their respective holders. MRV-OP-SFPMR3553IR1-092507 3020020-001 Rev. A1 Copyright ©2007 MRV Communications, Inc. All Rights Reserved.