DF15005S thru DF1510S SURFACE MOUNT GLASS PASSIVATED BRIDGE RECTIFIERS SINGLE-PHASE GLASS BRIDGE REVERSE VOLTAGE - 50 TO 1000 VOLTS FORWARD CURRENT - 1.5 AMPERES FEATURES MECHANICAL DATA Rating to 1000V PRV Ldeal for printed circuit board Reliable low cost construction utilizing molded Plastic technique results in inexpensive product Lead in plated copper The plastic material has UL flammability Classification 94V-0 Polarity As marked on body Weight 0.02 ounce, 0.38gram Mounting position Any MAXIMUM RATIXGS AND ELECTRICAL CHARACTERISTICS Ratings at 25oC ambient temp. unless otherwise specified Single phase, half sine wave, 60Hz, resistive or inductive load For capacitive load, derate current by 20% DF 15005S DF 1501S DF 1502S DF 1504S DF 1506S DF 1508S DF 1510S UNITS 1000 Volts Volts Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 Maximum RMS Bridge input Voltage VRMS 35 70 140 280 420 560 700 Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Maximum Average Forward Rectified Current @ TA=400C V(AV) 1.5 Amps Peak Forward Surge Current, 8.3ms Single Half Sine-Wave Superimposed on Rated Load (JEDEC Method) IFSM 50 Amps Maximum DC Forward Voltage at ADC VF 1.1 Volts Maximum DC Reverse @TJ=25 C at rated DC Blocking Voltage @TJ=1250C IR 10 500 A I2 t Rating for fusing (t<8.3ms) I2 t 10.4 A2S CJ 25 0 Typical Junction capacitance per element (Note 1) Typical Thermal resistance (Note 2) Operating Temperature Range Storage Temperature Range R 40 JC Volts pF 0 C/W TJ -55 to +150 0 TSTG -55 to +150 0 NOTES 1. Measured at 1.0 MHz and Applied Reverse Voltage of 4.0 Volts DC 2. Thermal Resestance From Junction to Ambient and from junction to lead mounted on P.C.B with 0.5 x 0.5 (13x13mm) copper pads. www.paceleader.tw 1 C C DF15005S thru DF1510S SURFACE MOUNT GLASS PASSIVATED BRIDGE RECTIFIERS SINGLE-PHASE GLASS BRIDGE RATING AND CHARACTERISTICS CURVES DF15005S THRU DF1510S Fig. 2 - MAXIMUM NON-REPETITIVE SURGE CURRENT PEAK FORWARD SURGE CURRENT, AMPERES AVERAGE FORWARD CURRENT AMPERES Fig. 1 - FORWAED CURRENT DERATING CURVE 1.50 1.25 1.00 0.75 0.50 0.25 SINGLE PHASE HALF WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD 0.00 20 40 60 80 100 120 140 50 40 30 20 10 Single Half Sine-Wave (JEDEC METHOD) 0 1 o AMBIENT TEMPERATURE, C 2 5 10 20 50 100 NUMBER OF CYCLES AT 60Hz Fig. 3 - TYPICAL JUNCTION CAPACITANCE Fig. 4 - TYPICAL FORWARD CHARACTERISTICS 10 INSTANTANEOUS FORWARD CURRENT, (A) CAPACITANCE, (pF) 100 10 1.0 0.1 o TJ=25 C PULSE WIDTH:300 2% DUTY CYCLE o TJ=25 C, f=1MHz 1.0 0.1 1.0 4.0 10.0 0.01 100 0 0.2 0.4 Fig. 5 - TYPICAL REVERSE CHARACTERISTICS INSTANTANEOUS REVERSE CURRENT, ( A) 100 o TJ=125 C 10 1.0 o TJ=25 C 0.1 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) www.paceleader.tw 0.6 0.8 1.0 1.2 1.4 1.6 INSTANTANEOUS FORWARD VOLTAGE, VOLTS REVERSE VOLTAGE, VOLTS 2 S 1.8