WWW.PHIHONG.COM 1.3 Watt – Unregulated Wall Plug PLA01A Linear Replacement Features • EISA Level IV Compliant • 90 – 264 VAC Input Range • High Efficiency • Light Weight • • • Lower Cost than Regulated Zero Minimum Load Double Insulated Applications • Wireless Communications • Cordless Head Set • • Blue Tooth Device Charger Cell Phone • • Height: 35 mm (1.38 in) Weight: 58 g ( 2.05 oz) Safety Approvals • UL / cUL 60950-1 Mechanical Characteristics • Length: 50.5 mm (2.0 in) • Width: 25 mm (0.98 in) Dimension Diagram Unit: mm (inch) Output Voltage / Current Characteristics Curve Model Nameplate Voltage PLA01A-050-R PLA01A-090-R PLA01A-120-R 5.0 V 9.0 V 12.0 V PLA01A-050-R PLA01A-090-R PLA01A-120-R WWW.PHIHONG.COM PLA01A Characteristics INPUT: AC Input Voltage Range 90 to 264VAC AC Inrush Current 40A max @ 240VAC, 25°C Input Power Saving <0.3W max @ 120/240VAC, no load California Energy Commission Compliant, Level IV Efficiency ≥ 52.4 % OUTPUT: Ripple (1) 150 mVp-p Over Voltage Protection 5VDC: OVP shall not exceed 15V Max 9VDC: OVP shall not exceed 18V Max 12VDC: OVP shall not exceed 24V Max Short Circuit Protection Auto Recovery ENVIRONMENTAL: Operation Temperature (Convection) 0°C ~ 40°C Storage Temperature -40°C ~ 85°C Humidity 90% RH Max Emissions FCC Class B EN55022 class B Note: (1) Measured after 10 minutes with by-pass capacitors 0.1uf / 10uf at output connector terminal and oscilloscope set at 20 MHz. Phihong reserves the right to make changes without further notice. Please consult Phihong USA and visit www.phihong.com for the most up-to-date specifications. 11-11-08 WWW.PHIHONG.COM Immunity EN61000-4-2, Level 3 EN61000-4-5, Level 3 General Leakage Current ≤ 10 uA max Dielectric Withstand (Hi-pot) 3KVAC, Primary to Secondary MTBF (Full Load, 25°C) 100K Hrs. min. at max load, 25°C ambient and 120VAC DC Output Connector 2.1 mm x 5.5 mm Center Positive AC Input Clip Fixed US blade