Model 6554 Microline Passive Oscilloscope Probe Accessories included with Probe: Model 6554 Microline Passive Oscilloscope Probe Features • • • • • USA: This probe is recommended for high performance probing applications and is adjustable for low and high frequencies. The probe's entire core is made of a high quality ceramic hybrid. Pure coaxial design and laser trimmed resistors ensure highest signal fidelity along the signal path offering high bandwidth and fast risetimes for accurate impulse measurements. Probe tips are interchangeable and can be replaced easily. Accessories (one of each) included with Probe are: BNC Adapter Ground Blade Ground Spring Ground Lead with Alligator Clip 11 cm (4.33”) IC Caps: 0.8mm, 1.0mm, and 1.27mm pitch Insulating Cap Protection Cap Solid Tip 0.8mm (0.0315”) Spring Tips 0.8mm (0.0315”) & 0.38mm (0.015”) Sprung Hook Trimmer Tool 2 Footer Positioner Coding Rings (Set) 3 X 4 colors Copper (Cu) Pads Sales: 800-490-2361 Technical Support: [email protected] Fax: 425-446-5844 Europe: 31-(0) 40 2675 150 International: 425-446-5500 Where to Buy: www.pomonaelectronics.com • Our passive probes are spring loaded, with needle sharp tips to support precise and safe measurements. Specifications Attenuation Ratio Maximum Input Voltage CAT II¹ Scope Bandwidth MHz System Bandwidth MHz (-3 dB) System Risetime (ns) Probe Input Resistance (MΩ) Probe Input Capacitance (pF) Compensation Range (pF) Cable Length 10:1 300 Vrms 500 500 < 0.7 10 < 11 10 - 20 4 ft. (1.2 m) 1 Rating: Per IEC 61010-031. Maximum voltage allowed on the low or ground connection including shell and housing must not exceed 30 V. Ordering Information Model: 6554 500 MHz O-Scope Probe All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Copyright © 2008 D2015549 Rev. 002 Page 1 of 1