AND1013ST-30/-EO 160 x 128 Dots Intelligent Graphics Display The AND1013ST-30/-EO devices are compact, full dot matrix, LCD modules that have an on-board LCD controller (T6963C) and display memory (RAM). The AND1013ST-30 /EO can display TEXT information, numerals, letters and symbols, as well as GRAPHIC patterns. These devices are suitable for medical and measurement equipment, point-ofsale terminals, portable equipment, and marine instrumentation. Features • • • • • • • • Super twisted, transflective, gray mode RoHS Compliant 20 characters x 16 line capability 160 x 128 dot graphic display Excellent readability and high-contrast ratio Built-in LCD controller (T6963C) Wide operating temperature range (0° to 50°C) Available with EL backlighting (-EO option) or fiberoptic backlight Dot Matrix Dimensions Absolute Maximum Ratings Item Symbol Rating VDD 7.0 VEE 24 VEL 130 (EO) Vrms Input Voltage VIN GND ≤ VIN ≤ VDD V Operating Temperature Top 0 to +50 °C Storage Temperature Tstg -10 to +60 ˚C Supply Voltage Unit V Electrical Characteristics (TA = 25°C) Item Symbol Min. Typ. Max. VDD 4.75 5.0 5.25 VEE 11.7 12.4 12.8 High Level In Voltage (VDD = 5.0V) VIH VDD – 2.2 – VDD Low Level In Voltage (VDD = 5.0V) VIL – – 0.5 High Level Output Volt. (VDD = 5.0V) VOH VDD –0.3 – – V Low Level Output Volt. (VDD = 5.0V) VOL – – 0.3 V IDD – – 10.0 IEE – – 2.0 – 15 Supply Voltage Mechanical Characteristics Item Outline Dimensions Specification Unit 129.0 (W) x 104.5 (H) x 14.0 Max (D) mm Number of Dots 160 x 128 dots # of Characters 20 x 16 (320), 8 x 8 font Power Consumption(1) Viewing Area 101.0 (W) x 82.0 (H) mm Bezel Opening 101.0 (W) x 82.0 (H) mm Dot Size 0.56 (W) x 0.56 (H) mm Dot Pitch 0.60 (W) x 0.60 (H) mm 150 gram Weight (approx.) 12/22/06 IEL Unit V V mA (2) 1. All dots on. (VDD = .5V, V EE = –8.5V, V EL=110, fEL = 500 Hz or at Typ. ) 2. mA rms Product specifications contained herein may be changed without prior notice. It is therefore advisable to contact Purdy Electronics before proceeding with the design of equipment incorporating this product. Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085 Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 1 AND1013ST-30/-EO Intelligent Graphics Display Optical Characteristics (TA = 25˚C, φ = 0°, θ = 0) Item Power Supply Symbol Min. Typ. Max. Right to Left – 80 – Up & Down – 55 – Contrast K 2.5 3.8 – – Turn On Ton – 200 350 ms Temperature V DD –VEE Turn Off Toff – 250 350 ms 0°C 14.1 +25°C 13.0 +50°C 11.1 Viewing Angle Unit degree Note:Refer to Applications Section for definitions of viewing angle, contrast ratio, response time (on and off) and luminance. The LCD panel is driven by the voltage VDD –VEE, so an adjustable VEE is required for contrast control and temperature compensation. Temperature Variations Example of Variable Negative Voltage Supply Connector Pin Assignment V DD Pin No. Signal Function 1 FGND Frame Ground (connected to metal bezel) 2 GND Ground (signal) 3 VDD Power Supply for logic (5V) 4 VEE Power Supply for LCD Drive GND R1 R2 LCD Module TR V EE R1 = 10k, R2 = 10k, TR 2SA1102 or equivalent 5 WR Data Write Timing Relationships and Diagram 6 RD Data Read Signal Timing Relationships 7 CE Chip Enable 8 C/D WR = “L”, C/D = “H”: Command Write WR = “L”, C/D = “L”: Data Write RD = “L”, C/D = “H”: Status Read RD = “L”, C/D = “L”: Data Read 9 NC No connection CE, RD, WR Pulse Width 10 RESET Controller Reset 11 D0 12 Symbol Min. Max. C/D Set Up Time tCDS 100 – C/D Hold Time tCDH 10 – tCE, tRD, tWR 80 – Data Set Up Time tDS 80 – Data Input/Output Data Hold Time tDH 40 – D1 Data Input/Output Access Time tACC – 150 13 D2 Data Input/Output Output Hold Time 50 D3 Data Input/Output tOH 10 14 15 D4 Data Input/Output 16 D5 Data Input/Output 17 D6 Data Input/Output 18 D7 Data Input/Output 19 NC No connection 20 NC No connection Item Unit ns Timing Diagram C/D tCDH tCDS CE tCP,tRD,tWP RD, WR tDS D0-D7 (WRITE) tDH D0-D7 (READ) tACC 2 Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085 Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com tOH 12/22/06 AND1013ST-30/-EO Intelligent Graphics Display Block Diagram 8 D0-D7 D0-D7 8 I/O0-I/O7 RAM 12 AD0-AD12 A0-A11 R/W R/W CE CE1 Because signal lines are directly connected to C-MOS and are not pull-up or pull-down internally, except RESET which is pull-up to VDD, you must guard all signals from external noise. WR RD T6963C CE C/D RESET HALT HSCP FR LP CDATA Control Lines X-Driver X-Driver 80 80 64 Y-Driver LCD 64 Y-Driver Dimensional Outline 12/22/06 Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085 Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 3