05E1L RECTRON THRU SEMICONDUCTOR TECHNICAL SPECIFICATION 05E6L SURFACE MOUNT SUPER FAST RECTIFIER VOLTAGE RANGE 50 to 400 Volts CURRENT 0.5 Ampere FEATURES * * * * * * * High reliability Low leakage Low forward voltage High current capability Super fast switching speed High surge capability Good for switching mode circuit SOD-123FL .114 (2.9) .106 (2.7) MECHANICAL DATA * * * * * Case: Molded plastic Epoxy: Device has UL flammability classification 94V-O Lead: MIL-STD-202E method 208C guaranteed Mounting position: Any Weight: 0.016 gram .035 (0.90) .028 (0.70) .077 (1.95) .069 (1.75) .008 MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (0.20) .039 (1.00) .035 (0.90) .030 (0.75) .022 (0.55) Ratings at 25 o C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. .150 (3.8) For capacitive load, derate current by 20%. .142 (3.6) Dimensions in inches and (millimeters) MAXIMUM RATINGS (At T A = 25oC unless otherwise noted) RATINGS SYMBOL 05E1L 05E2L 05E3L 05E4L 05E5L 05E6L UNITS Maximum Recurrent Peak Reverse Voltage VRRM 50 100 150 200 300 400 Volts Maximum RMS Volts VRMS 35 70 105 140 210 280 Volts VDC 50 100 150 200 300 400 Volts Maximum DC Blocking Voltage Maximum Average Forward Current at T A = 55 oC IO Peak Forward Surge Current I FM (surge):8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Typical Junction Capacitance (Note 2) 0.5 15 I FSM CJ Operating and Storage Temperature Range Amps Amps 12 14 pF 0 -55 to + 150 T J , T STG C ELECTRICAL CHARACTERISTICS (At TA = 25oC unless otherwise noted) CHARACTERISTICS Maximum Forward Voltage at 0.5A DC SYMBOL VF Maximum DC Reverse Current @T A = 25 o C at Rated DC Blocking Voltage @T A =100 o C Maximum Reverse Recovery Time (Note 1) NOTES : 1. Test Conditions: IF=0.5A, I R=-1.0A, IRR=-0.25A. 2. Measured at 1 MHZ and applied reverse voltage of 4.0 volts. 3.“Fully ROHS compliant”, “100% Sn plating (Pb-free)”. IR 05E1L 05E2L 05E3L 05E4L 0.95 05E5L 05E6L 1.25 UNITS Volts 5.0 uAmps 100 trr 35 nSec 2006-3 REV:O RATING AND CHARACTERISTIC CURVES ( 05E1L THRU 05E6L ) FIG. 1 - TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC FIG. 2 - TYPICAL FORWARD CURRENT DERATING CURVE trr +0.5A (-) 0 1 NONINDUCTIVE OSCILLOSCOPE (NOTE 1) (+) -1.0A 1cm NOTES:1 Rise Time = 7ns max. Input Impedance = SET TIME BASE FOR 10 ns/cm 1 megohm. 22pF. 2. Rise Time = 10ns max. Source Impedance = 50 ohms. FIG. 3 - TYPICAL REVERSE CHARACTERISTICS TJ = 25 .1 .01 4L 1.0 05E 1.0 CHARACTERISTICS 10 .1 1L~ TJ = 100 TJ = 25 Pulse Width = 300uS 1% Duty Cycle .01 .001 0 20 40 60 80 100 120 0 140 JUNCTION CAPACITANCE, (pF) 20 8.3ms Single Half Sine-Wave (JEDEC Method) 15 12 9 6 3 0 1 2 5 10 20 50 NUMBER OF CYCLES AT 60Hz 100 .4 .6 .8 1.0 1.2 1.4 FIG. 6 - TYPICAL JUNCTION CAPACITANCE FIG. 5 - MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 25 .2 INSTANTANEOUS FORWARD VOLTAGE, (V) PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) PEAK FORWARD SURGE CURRENT, (A) 0 25 50 75 100 125 150 175 AMBIENT TEMPERATURE ( 05E TJ = 150 10 0 FIG. 4 - TYPICAL INSTANTANEOUS FORWARD INSTANTANEOUS FORWARD CURRENT, (A) INSTANTANEOUS REVERSE CURRENT, (uA) 100 0.5 6L (NOTE 2) -0.25A 05E PULSE GENERATOR Single Phase Half Wave 60Hz Resistive or Inductive Load 5L~ D.U.T (+) 25 Vdc (approx) (-) 1.0 05E 10 NONINDUCTIVE AVERAGE FORWARD CURENT, (A) 50 NONINDUCTIVE 200 100 60 40 20 05E1 L~05E 10 6 4 TJ = 25 4L 05E5L~0 5E6L 2 1 .1 .2 .4 1.0 2 4 10 20 40 100 REVERSE VOLTAGE, ( V ) RECTRON ) Mounting Pad Layout 0.014 MIN. (0.36 MIN.) 0.029 MIN. (0.73 MIN.) 0.150 (3.80) REF Dimensions in inches and (millimeters) RECTRON