SDR12 Series Solid State Devices, Inc. 14830 Valley View Blvd * La Mirada, Ca 90638 Phone: (562) 404-7855 * Fax: (562) 404-1773 [email protected] * www.ssdi-power.com 12 AMPS 200 - 1000 VOLTS 5 µsec STANDARD RECOVERY RECTIFIER Designer’s Data Sheet • • • • • • • • FEATURES: Standard Recovery: 5 µsec maximum PIV up to 800 Volts High Current Operation up to 12 A Hermetically Sealed Single Chip Construction Low Thermal Resistance TX, TXV, and Space Level Screening Available Fast and Ultrafast Recovery Versions Available. Contact Factory. Axial MAXIMUM RATINGS Surface Mount Square Tab (SMS) Symbol Value Units VRRM VRWM VR 200 400 600 800 1000 Volts IO 12 Amps IFSM 150 Amps Operating and Storage Temperature TOP & Tstg -65 to +175 Maximum Thermal Resistance Junction to Lead, L = 0.125” (Axial Lead) Junction to End Tab (Surface Mount ) RθJL RθJE 6 4 Peak Repetitive Reverse Voltage and DC Blocking Voltage SDR12D SDR12G SDR12J SDR12K SDR12M Average Rectified Forward Current (Resistive Load, 60 Hz, Sine Wave, TA = 55oC) Peak Surge Current (8.3 ms Pulse, Half Sine Wave, Superimposed on IO, allow junction to reach equilibrium between pulses, TA = 25oC) NOTE: All specifications are subject to change without notification. SCD's for these devices should be reviewed by SSDI prior to release. DATA SHEET #: RC0091A o C o C/W DOC SDR12 Series Solid State Devices, Inc. 14830 Valley View Blvd * La Mirada, Ca 90638 Phone: (562) 404-7855 * Fax: (562) 404-1773 [email protected] * www.ssdi-power.com ELECTRICAL CHARACTERISTICS Instantaneous Forward Voltage Drop (IF = 12 Amps, TA = 25oC, 300µsec Pulse) Reverse Leakage Current (At Rated VR, 300µsec pulse minimum) Junction Capacitance (VR = 10 VDC, TA = 25oC, f = 1 MHz) Reverse Recovery Time (IF = 500 mA, IR = 1 A, IRR = 250 mA, TA = 25oC) Case Outline: (Axial) Case Outline: (SMS) Symbol Min Max Unit TA = 25oC TA = -55oC VF1 VF2 –– –– 1.30 1.50 TA = 25oC TA = 100oC IR1 IR2 –-–– 5.0 200 µA µA CJ –– 80 pF trr –– 5 µs Volts Volts DIM MIN MAX A B C D –– 0.140” 0.057” 0.500” 0.190” 0.180” 0.063” –– DIM MIN MAX A B C D 0.195” 0.190” 0.020” 0.002” 0.210” 0.230” 0.030” –– Note: Dimensions prior to soldering. NOTES: Consult manufacturing for operating curves.