Medically Approved 350W PC Power Supply for 1U Installation Product # TMPC-350-1U Features • • • • • • • • • • • • • • Complies with EPS 1U 2.0 90 to 264 VAC universal input Meets 1U Height Constraints High Efficiency Low Ripple & Noise Input Line Fuse Protection 7.48” L * 3.94” W * 1.59” H Output Overvoltage Protections Short Circuit Protection on All Outputs Active Power Factor Correction (PFC) meets EN61000-3-2 UL, cUL, VDE, CE Approved to UL 60601-1, EN 60601-1, IEC 60601-1 Meets FCC Part 18 Subpart C, EN60601-1-2, EN55011, CISPR 22 MTBF > 100,000 hours @ 25°C 100% Burn-in @ 50°C 100% Hi-Pot Test Input Specifications Voltage: 90-264 VAC Frequency: 47-63 Hz Input current: 6A max. @115VAC, 3A max. @230VAC Earth leakage current: 220µA max. @264 VAC/63Hz Output Specifications DC Output Voltage Minimum Load *Maximum Load Regulation Ripple & Noise P-P (Max.) +3.3V 0.5A 16.0A ± 5% 50mV +5V 0.5A 18.0A ± 5% 50mV +12V1 1.0A 16.0A ± 5% 120mV +12V2 1.0A 16.0A ± 5% 120mV -12V 0A 0.5A ± 10% 120mV -5V 0A 0.2A ± 10% 100mV +5Vsb 0A 2.5A ± 5% 50mV *Maximum overall output is 350W. *Total output on +3.3V and +5V shall not exceed 130W. *Total output on +12V1, +12V2, +5V, and +3.3V shall not exceed 331W *Maximum load on +12V1 and +12V2 shall not exceed 24A Other Specifications Inrush current: 60A/100A cold start at 115/230 VAC, 25°C ambient Overload protection: 150% Max. Overvoltage protections: +3.3V: 3.5-4.8V; +5V: 5.5-6.82V; +12V1 and +12V2: 13.4-15.6V Power good signal: turn-on delay 100 msec to 500 msec Power fail signal delay time: 1 msec min. Hold up time: 17ms min. at full load and nominal input voltage Efficiency: 80% min. at full load Temperature range: Operating 0°C-50°C; Non-operating -20°C-80°C Humidity: Operating 5-90% RH, non-condensing; Non-operating 5-95% RH, non-condensing Temperature coefficient: 0.01%°C Tumbler Technologies + TRUMPower Santa Clara, California USA • Phone 408-988-6616 • [email protected] • www.TRUMPower.com