Medically Approved 180W PC Power Supply for 1U Application Product # TMPC-180-1U Features • • • • • • • • • • • • • • Complies with SFX12V 2.0 90 to 265 VAC Universal Input Meets 1U Height Constraints High Efficiency Low Ripple & Noise Input Line Fuse Protection 7.48” L * 3.21” W * 1.59” H Output Overvoltage Protections 90-265 VAC full range input + PFC Short Circuit Protection on All Outputs 12V P4 connector Active Power Factor Correction (PFC) meets EN 61000-3-2 UL, cUL, VDE, CE Approved to UL 60601-1, EN 60601-1, IEC 60601-1 Meets FCC Part 18 Subpart C, EN60601-1-2, EN55011, CISPR 11 Class B MTBF > 100,000 Hours @ 25°C 100% Burn-in @ 50°C 100% Hi-Pot Test Input Specifications Voltage: 90-265 VAC Frequency: 47-63Hz Input current: 4A max. @115VAC/60Hz, 2A max. @230 VAC/50Hz Leakage current: 0.3mArms max. @264 VAC/63Hz, AC to safety ground Output Specifications DC Output Voltage Minimum Load *Regulation Normal Load *Maximum Load Load Line Ripple & Noise P-P (Max.) +3.3V 0.3A 8.4A 16.8A/4.5A ±5% ±1% 50mV P-P +5V 0.3A 6A 12A/9A ±5% ±1% 50mV P-P +12V 1.5A 6A 12A/9A ±5% ±1% 120mV P-P -12V 0A 0.4A 0.8A ±10% ±2% 120mV P-P +5Vsb 0A 1A 2.0A ±5% ±1% 50mV P-P *Total output on +3.3V and +5V shall not exceed 61W. *Total output on +3.3V, +5V and +12V shall not exceed 165W, and is limited to 180W total power. *+3.3V, +5V, +12V, and -12V will have ±10% regulation with all loads removed. Other Specifications Inrush current: 50A/80A cold strat at 115/230 VAC, 25°C ambient Overload protection: 150% Max Overvoltage protections: +5V: 5.7-6.5V; +3.3V: 3.7-4.5V; +12V: 13.3-15.6V Power good signal: turn-on delay 100 msec to 500 msec Power fail signal delay time: 1 msec min. Hold up time: 17ms min. at full load and nominal input voltage Efficiency: 68% min. at full load Temperature range: Operating 0°C-50°C; Non-operating: -20°C-80°C Humidity: 5-95% RH, non-condensing Temperature coefficient: 0.01%°C Tumbler Technologies + TRUMPower Santa Clara, California USA • Phone 408-988-6616 • [email protected] • www.TRUMPower.com