A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT CHIP LED LAMPS Right Angle Lens Super Yellow SMD Chip LED Lamps Part Number: AL-HKB34A Package outlines & Re-flow Profile Reflow Temp/Time Soldering iron Basic spec is U 5sec when 260℃. If temperature is higher, time should be shorter (+10℃Æ -1sec ).Power dissipation of iron should be smaller than 15W, and temperatures should be controllable .Surface temperature of the device should be under 230℃ . For Reflow Soldering For upright mounting ITEM MATERIALS Resin (mold) Epoxy Lens color Water Clear Printed circuit board BT Dice AlGaInP Emitted color Super Yellow For right anoge mounting NOTES: 1. All dimensions are in millimeters (inches); 2. Tolerances are ±0.1mm (0.004inch) unless otherwise noted. 2006/10/11 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT CHIP LED LAMPS Part Number: AL-HKB34A ELECTRO-OPTICAL CHARACTERISTICS Test Condition Symbol Parameter Viewing angle at 50% IV Forward voltage Luminous intensity (TA=25℃) (Typ.) (Max.) (Min.) (Typ.) IF=10mA 2θ1/2 IF=20mA VF IF=20mA IV Wavelength IF=20mA Spectral Line Half-Width IF=20mA Peak pulsing current (1/10 duty f=1kHz) Unit 100 Deg 2.10 2.60 42.0 V mcd λp 70.0 590 λd 587±5 △λ 30 nm IFP 100 mA Absolute maximum ratings Parameter Value nm (TA=25℃) Symbol Value Unit Forward current IF 30 mA Reverse voltage VR 5 V Reverse current IR 100 µA Power Dissipation PD 100 mW Operating temperature range Top -25 ~+80 ℃ Storage temperature range Tstg -30 ~+85 ℃ Lead soldering temperature 260℃ For 5 Seconds 2006/10/11 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT CHIP LED LAMPS Part Number: AL-HKB34A Test items and results of reliability ＊Refer to reliability test standard specification for in this line. 2006/10/11 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT CHIP LED LAMPS Part Number: AL-HKB34A Typical Optical-Electrical Characteristic Curves 2006/10/11 A-BRIGHT A-BRIGHT INDUSTRIAL CO., LTD. SURFACE MOUNT CHIP LED LAMPS Part Number: AL-HKB34A Typical Optical-Electrical Characteristic Curves 2006/10/11