Detector/Amplifier Hybrids With Feedback Resistor SD 112-42-11-221 PACKAGE DIMENSIONS INCH 2 1 3 4 TO-5 PACKAGE See See Sheet sheet22for forSchematic schematic and Diagram CHIP DIMENSIONS and connection connection diagram FEATURES • • • • Low noise Red enhanced Feedback circuit High speed DESCRIPTION APPLICATIONS The SD 112-42-11-221 is a detector/amplifier hybrid that combines a silicon photodiode with an opamp with a feedback resistor and capacitor, available in a hermetic TO-5 metal can package. • Instrumentation • Industrial • Medical SPECTRAL SENSITIVITY ABSOLUTE MAXIMUM RATING (TA)= 23°C UNLESS OTHERWISE NOTED Vs Voltage Supplies P Power Dissipation TSTG Storage Temperature TS Soldering Temperature* MIN TYP ±5 MAX UNITS ± 15 V 360 -25 mW +100 +240 °C °C 7 Sensitivity (104V/W) SYMBOL PARAMETER 6 5 4 3 2 °C 1 Wavelength (nm) ELECTRO-OPTICAL CHARACTERISTICS RATING SYMBOL f3db Gain S Vos Is Vn CHARACTERISTIC Cutoff Frequency Transimpedance Gain Sensitivity Output Offset Voltage Power Supply Current Broadband Noise (TA)= 23°C, VS = ± 12V UNLESS OTHERWISE NOTED TEST CONDITIONS MIN 500 l= 940 nm TYP UNITS ±1 7 60 KHz MW V/W mV mA uVrms 750 0.1 6.3x104 6.2 f= 10Hz to cutoff MAX Information in this technical datasheet is believed to be correct and reliable. However, no responsibility is assumed for possible inaccuracies or omission. Specifications are subject to change without notice. Advanced Photonix Inc. 1240 Avenida Acaso, Camarillo CA 93012 • Phone (805) 987-0146 • Fax (805) 484-9935 • www.advancedphotonix.com REV 8/22/06 1200 1150 1100 1050 950 1000 900 850 800 750 700 650 600 550 500 450 400 350 300 200 250 0 * 1/16 inch from case for 3 seconds max. Detector/Amplifier Hybrids With Feedback Resistor SD 112-42-11-221 SCHEMATIC AND CONNECTION DIAGRAM 3 0.01 PF 4 1 2 0.01 PF Note: Components shown outside the dashed area are external to the device, and must be supplied by the user. 2