5 Watts, 100 Ω General Specifications Resistive Element: Substrate: Terminals: Surface Mount Resistors Model RFP-100200-4Y100-2 Surface Mount Resistors Thick film Beryllium oxide ceramic Thick film silver Electrical Specifications Resistance Value: Frequency Range: Power: Capacitance: Features • DC - 3.0 GHz • 5 Watts • BeO Ceramic • Non-Nichrome Resistive Element 100 ohms, ±2% DC - 3.0 GHz 5 Watts 0.3 pF Notes: Tolerance is ±.010, unless otherwise specified. Operating temperature is -55°C to +125°C (see chart). Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions are in inches. Specifications subject to change without notice. • Low Capacitance • 100% Tested Outline Drawing Note: XXX denotes value VER. 12/5/01 Available on Tape and Reel for Pick and Place Manufacturing. Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369 1 Surface Mount Resistors Model RFP-100200-4Y100-2 Typical Performance Power Derating Suggested Mounting Procedures 1. Make sure that the devices are mounted on flat surfaces (.001” under the device) to optimize the heat transfer. 2. Position device on mounting surface and solder in place using a 60/40 type or an SN63 type solder. Available on Tape and Reel for Pick and Place Manufacturing. 2 Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369