10 Watts, 50 Ω General Specifications Resistive Element: Substrate: Cover: Lead(s): Thick film Aluminum nitride ceramic Alumina ceramic 99.99% pure silver (.005” thk) Electrical Specifications Features • DC – 6.0 GHz • 10 Watts • Aluminum Nitride (AlN) Ceramic • Welded Silver Leads • Non-Nichrome Resistive Element Resistance Value: Frequency Range: Power: V.S.W.R.: 50 ohms, ±5% DC - 6.0 GHz 10 Watts 1.25:1 Aluminum Nitride Flangeless Terminations Model RFP-10N50T Aluminum Nitride Terminations Notes: Tolerance is ±.010, unless otherwise specified. Operating temperature is -55°C to +150°C (see chart). Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions are in inches. Lead length 0.15” minimum. Specifications subject to change without notice. • Low VSWR • 100% Tested Outline Drawing .200 .075 .100 N50 .042 .050 VER. 12/5/01 Available on Tape and Reel for Pick and Place Manufacturing. Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369 1 Aluminum Nitride Flangeless Terminations Model RFP-10N50T Typical Performance Suggested Mounting Procedures Power Derating % OF RATED POWER .025 MIN. (2 PLACES) 100 75 BOARD LOWER THAN LEAD. SUGGESTED STRESS RELIEF METHODS 50 SCALE: 25 0 25 50 75 100 125 CASE TEMPERATURE — °C 2 BOARD EVEN WITH LEAD. 150 BOARD LOWER THAN LEAD. BOARD HIGHER THAN LEAD. NOT RECOMMENDED APPLICATION SCALE: 1. Make sure that the devices are mounted on flat surfaces (.001” under the device) to optimize the heat transfer. 2. Position device on mounting surface and solder in place using an SN96 type solder. 3. Solder leads in place using an SN63 type solder with a controlled temperature iron (700°F). Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369