Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS General Description Features The AZ339 series consists of four independent precision voltage comparators with an offset voltage specification as low as 2mV. The input common mode voltage range of these comparators includes ground, even when operated from a single power supply voltage. Operation from split power supplies is also possible and the low power supply current drain is independent of the magnitude of the power supply voltage. · · · · · · The AZ339 series is designed to directly interface with TTL and CMOS. · The AZ339 series can be widely used in such applications as battery charger, cordless telephone, switching power supply, DC-DC module and PC motherboard. · · AZ339 Wide Supply Voltage Range - Single Supply: 2.0V to 18V - Dual Supplies: ±1.0V to ± 9V Very Low Supply Current Drain: 0.8mA - Independent of Supply Voltage Low Input Bias Current: 25nA (Typical) Low Input Offset Current: ±5nA (Typical) Low Input Offset Voltage: ±2mV (Typical) Input Common Mode Voltage Range Includes Ground Differential Input Voltage Range Equals to the Power Supply Voltage Low Output Saturation Voltage: 250mV at 4mA Open Collector Output Applications The AZ339 series are available in 2 Packages: DIP-14 and SOIC-14. · · · · · · Battery Charger Cordless Telephone Switching Power Supply DC-DC Module PC Motherboard Communication Equipment DIP-14 SOIC-14 Figure 1. Package Types of AZ339 Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 1 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Pin Configuration M Package/P Package SOIC-14/DIP-14 OUTPUT 2 1 14 OUTPUT 3 OUTPUT 1 2 13 OUTPUT 4 VCC 3 12 GND INPUT 1- 4 11 INPUT 4+ INPUT 1+ 5 10 INPUT 4- INPUT 2- 6 9 INPUT 3+ INPUT 2+ 7 8 INPUT 3- Figure 2. Pin Configuration of AZ339 (Top View) Functional Block Diagram VCC 3.5µA +INPUT Q2 100µA 3.5µA 100µA Q3 Q1 Q4 OUTPUT -INPUT Q8 Q7 Q5 Q6 Figure 3. Functional Block Diagram of AZ339 (Each Comparator) Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 2 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Ordering Information AZ339 E1: Lead Free Blank: Tin Lead Circuit Type TR: Tape and Reel Blank: Tube Package M: SOIC-14 P: DIP-14 Package Temperature Range SOIC-14 -40 to 85 oC DIP-14 -40 to 85 oC Part Number Tin Lead Marking ID Lead Free Tin Lead Lead Free Packing Type AZ339M AZ339M-E1 AZ339M AZ339M-E1 Tube AZ339MTR AZ339MTR-E1 AZ339M AZ339M-E1 Tape & Reel AZ339P AZ339P-E1 AZ339P AZ339P-E1 Tube BCD Semiconductor's Pb-free products, as designated with "E1" suffix in the part number, are RoHS compliant. Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 3 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Absolute Maximum Ratings (Note 1) Parameter Symbol Value Unit Supply Voltage VCC 20 V Differential Input Voltage VID 20 V Input Voltage VIN -0.3 to 20 V Input Current (VIN < -0.3V) (Note 2) IIN 50 mA Power Dissipation (TA=25oC) PD DIP-14 1050 SOIC-14 890 Output Short Circuit to Ground Continuous Operating Junction Temperature TJ 150 Storage Temperature Range TSTG -65 to 150 TLEAD 260 Lead Temperature (Soldering, 10 seconds) mW o C oC o C Note 1: Stresses greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "Recommended Operating Conditions" is not implied. Exposure to "Absolute Maximum Ratings" for extended periods may affect device reliability. Note 2: This input current will only exist when the voltage at any of the input leads is driven negative. It is due to the collector-base junction of the input PNP transistors becoming forward biased and thereby acting as input diode clamps. In addition to this diode action, there is also lateral NPN parasitic transistor action on the IC chip. This transistor action can cause the output voltages of the comparators to go to the V+ voltage level (or to ground for a large overdrive) for the time duration that an input is driven negative. This is not destructive and normal output states will re-establish when the input voltage, which was negative, again returns to a value greater than -0.3 VDC (at 25oC). Recommended Operating Conditions Parameter Supply Voltage Operating Temperature Range Symbol Min Max Unit VCC 2 18 V TA -40 85 oC Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 4 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Electrical Characteristics VCC=5V, GND=0V, TA=25oC, unless otherwise specified. Parameter Conditions Min Typ Max Unit Input Offset Voltage (Note 3) 2.0 5.0 mV Input Bias Current IIN+ or IIN- with output in linear range, VCM=0V (Note 4) 25 250 nA Input Offset Current IIN+-IIN-, VCM=0V 5.0 50 nA Input Common Mode Voltage Range VCC=15V (Note 5) VCC-1.5 V Supply Current 0 RL=∞ on all comparators 0.8 2.0 RL=∞, VCC=18V 1.0 2.5 Voltage Gain RL≥15KΩ, VCC=15V, VO=1V to 11V Large Signal Response Time 50 mA 200 V/mV VIN=TTL logic swing, VREF=1.4V, VRL=5V, RL=5.1KΩ 300 ns Response Time VRL=5V, RL=5.1KΩ (Note 6) 1.3 µs Output Sink Current VIN-=1V, VIN+=0, VO≤1.5V 16 mA Saturation Voltage VIN-=1V, VIN+=0, ISINK ≤4mA 250 Output Leakage Current VIN-=0, VIN+=1V, VO=5V 0.1 6.0 400 mV nA Note 3: At output switch point, VO=1.4V, RS=0 with VCC from 5V to 15V, and over the full common-mode range (0V to VCC-1.5V), at 25oC. Note 4: The direction of the input current is out of the PNP input stage. This current is essentially constant, independent of the state of the output, so no loading charge exists on the reference of input lines. Note 5: The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V. The upper end of the common-mode voltage range is VCC-1.5V, but either or both inputs can go to +18V without damage, independent of the magnitude of VCC. Note 6: The response time specified is a 100mV input step with 5mV overdrive. For large overdrive signals 300ns can be obtained. Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 5 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Typical Performance Characteristics 1.3 30 1.2 -40C o 1.1 1.0 o Input Current (nADC) Supply Current (mA) 25 -40C 0.9 0.8 o 25C 0.7 0.6 o 85C 0.5 0.4 25C o 20 85C o 15 10 0.3 0.2 5 0.1 0.0 0 2 4 6 8 10 12 14 16 0 18 0 2 4 Supply Voltage (VDC) 6 8 10 12 14 16 18 Supply Voltage (VDC) Figure 4. Supply Voltage vs. Supply Current Figure 5. Supply Voltage vs. Input Current Output Voltage 1 0.1 6V 4V 2V 0 5mV Input Voltage Saturation Voltage (VDC) 10 o 25 C o 85 C 0.01 o -40 C 1E-3 0.01 0.1 1 10 VCC 5.1K -95mV VIN _ VOUT + 100 0 Output Sink Current (mA) 0.2 04 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 Time (µS) Output Voltage Figure 6. Output Sink Current vs. Saturation Voltage Figure 7. Response Time for 5mV Input Overdrive - Negative Transition 6V 4V 2V VCC 0V 5.1K VIN _ VOUT Input Voltage 95mV + -5mV 0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 Time (µS) Figure 8. Response Time for 5mV Input Overdrive - Positive Transition Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 6 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Typical Applications VCC +5.0V + 3 100K 3K +VIN 1/4 AZ339 + 1/4 MM54CXX 1/4 AZ339 +VREF - VO 12 - Figure 10. Driving CMOS/TTL Figure 9. Basic Comparator VCC VCC 4.3K 1M 10K 100K 100pF +VIN 75pF IN914 1M 1/4 AZ339 - VO 1/4 AZ339 + VO + 0.001µF 100K VIN 1M IN914 100K Figure 11. One Shot Multivibrator Figure 12. Squarewave Osillator Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 7 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Mechanical Dimensions SOIC-14 Unit: mm(inch) A 0.700(0.028) 0.280(0.011) ×45° 0.480(0.019)×45° 0.100(0.004) 0.250(0.010) 7° 8° 8° 0° 8° 9.5° 0.330(0.013) 0.510(0.020) 3.800(0.150) 4.000(0.157) 1.270(0.050) A 1.000(0.039) 1.300(0.051) 8° 0.190(0.007) 0.250(0.010) 8.550(0.337) 8.750(0.344) 1.350(0.053) 1.750(0.069) 7° 6.200(0.244) 5.800(0.228) 0.250(0.010) 0.200(0.008)MIN 20:1 R0.200(0.008) R0.200(0.008) 1° 5° 0.500(0.020) 0.600(0.024) 0.250(0.010) φ2.000(0.079) Depth 0.060(0.002) 0.100(0.004) Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 8 Data Sheet LOW POWER LOW OFFSET VOLTAGE QUAD COMPARATORS AZ339 Mechanical Dimensions (Continued) DIP-14 1.524(0.060) TYP 10° Unit: mm(inch) 0.700(0.028) 7.620(0.300)TYP 1.600(0.063) 1.800(0.071) 5° 10° 4° 4° 0.204(0.008) 0.360(0.014) 8.200(0.323) 9.400(0.370) 0.254(0.010) 0.360(0.014) 0.560(0.022) 2.540(0.100)TYP 3.000(0.118) 3.600(0.142) 0.510(0.020)MIN Φ3.000(0.118) Depth 0.100(0.004) 0.200(0.008) 1.600(0.063) 1.800(0.071) 0.130(0.005)MIN 6.200(0.244) 6.600(0.260) 18.800(0.740) 19.200(0.756) R1.000(0.039) Aug. 2006 Rev. 1. 2 BCD Semiconductor Manufacturing Limited 9 http://www.bcdsemi.com IMPORTANT NOTICE BCD Semiconductor Manufacturing Limited reserves the right to make changes without further notice to any products or specifications herein. BCD Semiconductor Manufacturing Limited does not assume any responsibility for use of any its products for any particular purpose, nor does BCD Semiconductor Manufacturing Limited assume any liability arising out of the application or use of any its products or circuits. BCD Semiconductor Manufacturing Limited does not convey any license under its patent rights or other rights nor the rights of others. MAIN SITE BCD Semiconductor Manufacturing Limited BCD Semiconductor Manufacturing Limited - Wafer Fab Shanghai SIM-BCD Semiconductor Manufacturing Limited 800, Yi Shan Road, Shanghai 200233, China Tel: +86-21-6485 1491, Fax: +86-21-5450 0008 - IC Design Group Advanced Analog Circuits (Shanghai) Corporation 8F, Zone B, 900, Yi Shan Road, Shanghai 200233, China Tel: +86-21-6495 9539, Fax: +86-21-6485 9673 REGIONAL SALES OFFICE Shenzhen Office Shanghai SIM-BCD Semiconductor Manufacturing Co., Ltd. Shenzhen Office Advanced Analog Circuits (Shanghai) Corporation Shenzhen Office 27B, Tower C, 2070, Middle Shen Nan Road, Shenzhen 518031, China Tel: +86-755-8368 3987, Fax: +86-755-8368 3166 Taiwan Office BCD Semiconductor (Taiwan) Company Limited 4F, 298-1, Rui Guang Road, Nei-Hu District, Taipei, Taiwan Tel: +886-2-2656 2808, Fax: +886-2-2656 2806 USA Office BCD Semiconductor Corporation 3170 De La Cruz Blvd., Suite 105, Santa Clara, CA 95054-2411, U.S.A Tel: +1-408-988 6388, Fax: +1-408-988 6386