Surface Mount Zener Diodes CZRW55C2V4-G thru CZRW55C39-G Voltage: 2.4 ~ 29 Volts Power: 410 mW Features: Planar Die Constructions 410mW Power Dissipation Zener Voltages from 2.4V ~ 39V SOD-123 Ideally Suited for Automated Assembly Processes .053 (1.35) .037 (0.95) .028 (0.70) .019 (0.50) .110 (2.80) .098 (2.50) .008 (0.20) Max. Case: SOD-123, Molded Plastic Terminals: Solderable per MIL-STD-202, Method 208 Approx. Weight: 0.008 gram .071 (1.80) .055 (1.40) .154 (3.90) .141 (3.60) Mechanical Data: .016 (.40) Min. .005 (.12) Max. Dimensions in inches and (millimeters) Maximum Ratings and Thermal Characterics Parameter Symbols Value Units Power Dissipation (Note A) at 75oC PD 410 mW IFSM 2 Amps TJ -55 to +150 Peak Forward Surge Current Surge, 8.3ms Single Half Sine-Wave Superimposed on Rated Load (JEDEC Method) (Note B) Operating Junction and Storage Temperature Range o C Notes: A. Mounted on 5.0mm2(.013mm thick) land areas. B. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum. “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com Page1 Surface Mount Zener Diodes CZRW55C2V4-G thru CZRW55C39-G Maximum Ratings and Electrical Characterics (TA=25°C unless otherwise noted) VF=1.2V max, IF=100mA for all types Nominal Zener Voltage Part Number VZ @ IZT Nom. V Min. V Max. Zener Impedance ZZT @ IZT Max. V Ohm mA ZZK @ IZK Ohm Max Reverse Leakage Current IR @ VR Max Zener Current IZM@ TA mA nA V mA 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 100000 75000 50000 25000 15000 10000 5000 5000 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 100 1 1 1 1 1 1 1 1 0.8 1 2 3 5 6 7 7.5 8.5 9 10 11 12 14 15 17 18 20 22.5 25 27 29 134 118 109 100 92 84 76 67 59 54 49 44 40 36 33 30 28 25 23 20 18 17 16 13 12 10 9 9 8 410 mWatts Zener Diodes CZRW55C2V4-G CZRW55C2V7-G CZRW55C3V0-G CZRW55C3V3-G CZRW55C3V6-G CZRW55C3V9-G CZRW55C4V3-G CZRW55C4V7-G CZRW55C5V1-G CZRW55C5V6-G CZRW55C6V2-G CZRW55C6V8-G CZRW55C7V5-G CZRW55C8V2-G CZRW55C9V1-G CZRW55C10-G CZRW55C11-G CZRW55C12-G CZRW55C13-G CZRW55C15-G CZRW55C16-G CZRW55C18-G CZRW55C20-G CZRW55C22-G CZRW55C24-G CZRW55C27-G CZRW55C30-G CZRW55C33-G CZRW55C36-G CZRW55C39-G 2.4 2.7 3.0 3.3 3.6 3.9 4.3 4.7 5.1 5.6 6.2 6.8 7.5 8.2 9.1 10.0 11.0 12.0 13.0 15 16 18 20 22 24 27 30 33 36 39 2.28 2.5 2.8 3.1 3.4 3.7 4 4.4 4.8 5.2 5.8 6.4 7 7.7 8.5 9.4 10.4 11.4 12.4 13.8 15.3 16.8 18.8 20.8 22.8 25.1 28 31 34 37 2.56 2.9 3.2 3.5 3.8 4.1 4.6 5 5.4 6 6.6 7.2 7.9 8.7 9.6 10.6 11.6 12.7 14.1 15.6 17.1 19.1 21.2 23.3 25.6 28.9 32 35 38 41 85 83 95 95 95 95 95 78 60 40 10 8 7 7 10 15 20 20 25 30 40 50 50 55 80 80 80 80 90 90 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 600 500 500 500 500 500 500 500 480 400 200 150 50 50 50 70 70 90 110 110 170 170 220 220 220 250 250 250 250 300 NOTE: 1.Tolerance and Type Number Designation. The type numbers listed have a standard tolerance on the nominal zener voltage of ±5%. 2.Specials Available Include: A. Nominal zener voltages between the voltages shown and tighter voltage tolerances. B. Matched sets. 3.Zener Voltage (VZ) Measurement. Guarantees the zener voltage when measured at 90 seconds while maintaining the lead temperature (TL) at 30OC, from the diode body. 4.Zener Impedance (ZZ) Derivation. The zener impedance is derived from the 60 cycle ac voltage, which results when an AC current having an rms value equal to 10% of the dc zener current (IZT or IZK) is superimposed on IZT or IZK. 5.Surge Current (IR) Non-Repetitive. The rating listed in the electrical characteristics table is maximum peak, non-repetitive, reverse surge current of 1/2 square wave or equivalent sine wave pulse of 1/120 second duration superimposed on the test current, IZT, per JEDEC registration; however, actual device capability is as described in Figure 5. “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com Page1 Surface Mount Zener Diodes CZRW55C2V4-G thru CZRW55C39-G 8 100 TEMPERATURE COEFFICIENT,mV/ o C) TEMPERATURE COEFFICIENT,mV/ o C) 7 6 5 4 3 10 2 1 0 -1 -2 -3 2 3 4 5 6 7 8 9 10 11 1 10 12 100 NOMINAL ZENER VOLTAGE, Volts NOMINALZENERVOLTAGE,Volts TYPICAL REVERSE CURRENT 1000 1000 IZ = 1 mA FORWARD CURRENT, mA DYNAMIC IMPEDANCE, O TJ=25 C IZ(AC)=0.1IZ(DC) F=1 kHZ 100 5 mA 20 mA 10 100 150OC 10 75OC 25OC 1 1 10 1 0.4 100 0.5 0.6 0.8 0.9 1.0 1.1 1.2 FORWARD VOLTAGE, Volts NORMAL ZENER VOLTAGE, Volts TYPICAL FORW ARD VOL TAGE 1000 1.2 0.8 0.6 PD V.S. TA 0.4 TA=25oC 0 V BIAS 1 V BIAS 1.0 CAPACITANCE, pF POWER DISSIPATION, Watts 0.7 5O C 100 BIAS AT 50% OF VZ NOM 10 0.2 0 25 50 75 100 TEMPERATURE ( oC) 125 150 155 1 1 10 100 NOMINAL ZENER VOLTAGE, Volts “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com Page1 Surface Mount Zener Diodes CZRW55C2V4-G thru CZRW55C39-G 100 100 TA=25oC o 10 ZENER CURRENT, mA ZENER CURRENT, mA TA=25 C 1 0.1 0.01 0 2 4 6 8 10 12 10 1 0.1 0.01 10 30 50 70 90 ZENER VOLTAGE, Volts ZENER VOLTAGE, Volts ZENER VOL TAGE V.S. ZENER CURRENT LEAKAGE CURRENT ( A) 1000 100 10 1 O +150 C 0.1 0.01 O 0.001 +25 C 0.0001 -55 C 0.00001 O 0 10 20 30 40 50 60 70 80 90 NOMINAL ZENER VOLTAGE, Vlots “-G” suffix designated RoHS compliant version Comhip Technology Corporation . Tel:510-657-8671 . Fax: 657-8921 . www.comchiptech.com Page1