Advanced Power Solutions 18-36 VDC INPUT RANGE DC-DC CONVERTER HALF-BRICK POWER MODULES 100-150 WATTS SINGLE & DUAL OUTPUT APS100HD-24B-S&D SERIES FEATURES: n SINGLE & DAUL OUTPUT n WIDE 2:1 INPUT RANGE n 1500VDC ISOLATION n STANDARD HALF-BRICK PACKAGE n HIGH-EFFICIENCY POWER MODULE n UNDER-VOLTAGE LOCKOUT n DESIGNED TO MEET INTERNATIONAL SAFETY STANDARDS SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Range: Wide 2:1 Input DC Range 18-36Vdc. Input Voltage: Nominal 24Vdc. Input Current: Typ. 6.85A full load and 0.06A no-load @ 24Vdc nominal input. Input Fuse: Use external fuse. Inrush Current: Peak 20A @ 24Vdc. Input Filter: Pi-Network for EMI suppression. Under-Voltage Protection (UVP): Lock-out activated at 17.8 Vdc input. Input Reflected Ripple Current: 28.4mA pk-pk @24 Vdc. Isolation Voltage: 1,500Vdc input-output. Remote On/Off: TTL/CMOS-Compatible input control. Logic input reference to -Vin. Logic [1]/Open(or 2.4Vdc above -Vin)=ON. Logic [0]/Short(or 0~0.08Vdc above -Vin)=OFF. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 100-150W continuous. Line Regulation: Typ. 0.1%. Load Regulation: Typ. ±1.0%. Noise & Ripple: Typ. 120mV, peak to peak. OVP: Built-in. Adjustability: Factory set. Overload Protection (OLP): Fully protected against overload and short circuit. Typical 130% max. load. Consult the factory for special OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 83.8-87%, various with input. Switching Frequency: Fixed frequency 330K Hz. Circuit Topology: Forward Circuit. Transient Response: Peak transient <220mV and recovers within 1mS after 25% load-change. Power Density: 36.0 Watts / Cubic inch. Operating Temperature: -40 to +100°C (baseplate). Storage Temperature: -40 to +100 °C. Temperature Coefficient: 0.02%/°C. Humidity: Up to 95% RH, Non-Condensing. Case: Aluminum baseplate. Industrial Grade. NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise spec. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full-Load (F-L) to Half-Load(H-L)at nominal input. (4) Correct fuse size by calculating the max. DC current drain at low Line input & adding 20-25% for desired fuse size. INPUT/OUTPUT & VOLTAGE/CURRENT RATINGS SINGLE OUTPUT MODEL NO. APS100HD-24B-S018 APS100HD-24B-S025 APS100HD-24B-S033 APS100HD-24B-S050 APS100HD-24B-S120 APS100HD-24B-S150 INPUT Vdc Range Nominal 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc OUTPUT VO1 ? @ # Min. Volt. Max. 24Vdc 24Vdc 24Vdc 24Vdc 24Vdc 24Vdc 0A 0A 0A 0A 0A 0A 1.8Vdc 2.5Vdc 3.3Vdc 5.0Vdc 12.0Vdc 15.0Vdc 30A 30A 30A 25A 12A 10A DUAL OUTPUT MODEL NO. APS100HD-24B-D025B APS100HD-24B-D033B APS100HD-24B-D033C APS100HD-24B-D050C APS100HD-24B-D050D INPUT Vdc Range Nominal 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 18-36Vdc 24Vdc 24Vdc 24Vdc 24Vdc 24Vdc OUTPUT VO1 ? @ Min. Typ. Volt. Max. 2.0A 2.0A 2.0A 2.0A 2.0A 18A 17A 17A 14A 14A MECHANICAL DIMENSIONS: MM [INCHES] 2.5Vdc 3.3Vdc 3.3Vdc 5.0Vdc 5.0Vdc 25A 24A 24A 20A 20A AUX. OUTPUT VO2 ? @ Min. Typ. Volt. Max. 0A 0A 0A 0A 0A 18A 18A 15A 15A 12A 1.8Vdc 1.8Vdc 2.5Vdc 2.5Vdc 3.3Vdc 25A 25A 20A 20A 18A WEIGHT: 73.0g (2.6 Oz.) PIN ASSIGNMENT PIN NO. SINGLE DUAL PIN# 1. +Vin +Vin PIN# 3. Remote ON/OFF CASE Remote ON/OFF CASE PIN# 4. -Vin -Vin PIN# 5. DC COM. VO2 PIN# 6. -SENSE DC COM PIN# 7. VO1 ADJ. VO2 ADJ. PIN# 8. +SENSE VO1 PIN# 9. VO1 DC COM PIN# 10. ------- VO1 ADJ. PIN# 2. SINGLE O/P DUAL O/P