11mm x 1.4mm BACKLIGHT AA1114/2YC/CC YELLOW Description Features LOW POWER CONSUMPTION. The Yellow source color devices are made with IDEAL FOR BACKLIGHTING. Gallium Arsenide Phosphide on Gallium Phosphide RoHS COMPLIANT. Yellow Light Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAB2773 REV NO: V.3 DATE: MAR/05/2005 PAGE: 1 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001463 Selection Guide Part No. Dice AA1114/2YC/CC Iv (mcd) @ 20mA Lens Type YELLOW (GaAsP/GaP) Viewing Angle Min. Typ. 2θ θ1/2 4 10 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Yellow λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAB2773 REV NO: V.3 DATE: MAR/05/2005 PAGE: 2 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001463 Yellow AA1114/2YC/CC Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength) , the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAB2773 REV NO: V.3 DATE: MAR/05/2005 PAGE: 3 OF 3 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: B.H.LI ERP: 1201001463